Whirlpool HC638 Use, Care And Installation Manual - Page 13
Browse online or download pdf Use, Care And Installation Manual for Ventilation Hood Whirlpool HC638. Whirlpool HC638 40 pages.
Print Page
(6)
Delay Off
-
Press this button once to enable delay off.
-
The default fan speed is 3. The 2
memorized fan speed.
-
The default time is 5 minutes. The 2
memorized time.
-
The delay off process will start with one beep sound and end by two
beep sound with light turn off as well.
-
Time set for delay off or alarm will be range from 1 min to 10 hrs. Press
Fan (+) button to increase time and L/R ( - ) button to decrease time.
-
When delay off function is enabled, auto clean cannot functioned.
(7)
Auto Clean
-
When fans are on or off,press this button to enable the auto clean.
- The hood shall be cleaned by using hood cleaner/detergent. Please
do not use abrasive cleaner/detergent which will damage the machine.
-
Cleaning Steps:
a. Mix the cleaner/detergent and water by pouring
them to the marked level of the provided water jug.
(the cleaner/detergent : water = 1:12).Pour the cleaner/
detergent mixture in the water inlet as shown in
the picture.
b. If the cleaner/detergent mixture comes out from
the excess water hole down into the oil cup, it means
that inside water tank is full and no more shall be
poured into the water tank.
c. Press the Auto Clean (
beep sound. The fans will change to low speed
for 3 seconds, and then the water pump will operate for 10 seconds.
Then fans change to high speed and start cleaning for 25 seconds.
The auto clean process will end with two beep sounds.
d. Dirty oil/water will be flowed into the oil cup.
-
When auto clean is enabled, press On/Off ( ) button to cancel at anytime.
-
If the water level is low, the hood will have beep sound and with display
indication. Refill with water and press Auto Clean (
cleaning process.
-
After operation of 15 hours, there will be clean reminder shown on display
every time when you turn off the machine. The reminder display disappear when
you enable the auto clean function or pressing On/Off (
H
O
OOD
PERATION
nd
time usage will follow the last
nd
time usage will follow the last
) button to start with one
9
cleaner/detergent
Water
water inlet
water tank
Excess water hole
) button to continue
) button for 3 seconds.