Whirlpool RANGE HOOD UXT2030AY Installation Instructions And Use & Care Manual - Page 8

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool RANGE HOOD UXT2030AY. Whirlpool RANGE HOOD UXT2030AY 28 pages. 30" (76.2 cm) and 36" (91.4 cm)
Also for Whirlpool RANGE HOOD UXT2030AY: Installation Instructions And Use And Care Manual (32 pages), Installation Instructions And Use & Care Manual (28 pages), Installation Instructions And Use & Care Manual (36 pages)

Print Page

NOTE: Your model will have a 7" (17.8 cm) round vent mounting

plate on the inside of your range hood.

1. Remove the 7" (17.8 cm) round vent mounting plate attached

with 3.5 x 9.5 mm screws on the inside of your range hood.

Use these screws to install the round vent mounting plate.

A. 7" (17.8 cm) round vent mounting plate

B. 3.5 x 9.5 mm screws

2. Lift the range hood up under cabinet and determine final

location by centering beneath cabinet. Mark on the underside

of cabinet the location of the 4 keyhole mounting slots on the

range hood. Set range hood aside on a covered surface.

A. Keyhole slot

3. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

A. Drill pilot hole

4. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot

holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads

and cabinet to slide range hood into place.

Install Range Hood

¹⁄₄"

(6.4 mm)

5. Remove top rectangular and round vent knockouts.

A. Round vent knockout

B. Top rectangular vent knockout

6. Install 7" (17.8 cm) round vent mounting plate. Attach to

range hood with the 3.5 x 9.5 mm screws provided.

NOTE: An optional 7" (17.8 cm) round damper is available as

an accessory. For information on ordering, see the

"Accessories" section.

A. 7" (17.8 cm) Round damper (see "Accessories" section)

B. 3.5 x 9.5 mm screws

C. 7" (17.8 cm) round vent mounting plate

D. Round vent knockout

E. Rectangular vent knockout

NOTE: The 7" (17.8 cm) round vent mounting plate can

be installed up to 1" (2.5 cm) on either side of the hood

center to accommodate off-center ductwork.