Whirlpool UTX5536AAB0 Installation Instructions And Use & Care Manual - Page 9

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool UTX5536AAB0. Whirlpool UTX5536AAB0 28 pages. 30" (76.2 cm) and 36" (91.4 cm) range hood installation instructions

Print Page
ns s
blo
1, Remove the grease filters. See the "Range Hood (}are"
•
If using rectangular vent, attach rectangular damper/vent
section,
connectors
to the range hood using sheet metal screws.
E
2. Remove mounting screws and lateral supports.
A. Vertical vent
B. Sheet metal screws
C. Hinge pin
D. Vent knockouts
E. Horizontal vent
4.
•
If using round vent, attach vent transition piece
(purchased separately) to range hood top using sheet
metal screws.
NOTE: If the wall cap is directly behind the vent
connector, the dampers in the connector and wall cap
must not interfere with each other. Remove the vent
connector damper if they interfere.
Lift the range hood up under cabinet and determine final
location by centering beneath cabinet. Mark on the underside
of cabinet the location of the 4 keyhole mounting slots on the
range hood. Set range hood aside on a covered surface.
A
\
A. Lateral supports
B. Mounting screws
3. For vented installations:
•
Depending on your installation, remove either top or rear
rectangular vent knockout. If using round vent, remove
top rectangular knockout.
NOTE: Do not remove rectangular knockouts if
installation of range hood is to be non-venting
(recirculating).
Make sure damper pivot is nearest to top/back edge of
range hood.
Remove tape from damper flap.
NOTE: The exhaust adaptor/damper
can be installed up
to 1" (2.5 cm) on either side of the hood center to
accommodate
off-center ductwork.
5.
6.
A. Keyhole slot
Use 1/8"(3 mm) drill bit and drill 4 pilot holes as shown.
A
A. Drill pilot hole
Install the 4 - #10 x %" mounting screws in pilot holes. Leave
about 1/4"(6.4 cm) space between screw heads and cabinet
to slide range hood into place.
1/4"
(6.4 ram)