Whirlpool UXI6536BS0 Use & Care Manual - Page 9
Browse online or download pdf Use & Care Manual for Ventilation Hood Whirlpool UXI6536BS0. Whirlpool UXI6536BS0 32 pages. 36"(91.4cm) island-mount canopy range hood
Print Page
1=
................
,
......
A
t' be 'ge
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
2. Position the 4 vertical supports (A) with the notches at the
bottom and attach to the range hood using 16 - 4 x 8 mm
screws.
3. Attach the horizontal support (B) using 8 - 4 x 8 mm screws.
4=
A
C
.........
..............
_4
A
............................................
C
A. Vertical supports
B. Horizontal support
C. Notched end
Attach a second set of vertical supports (A) and set the
vertical height (B). See "Installation Dimensions" in the
"Location Requirements"
section to help determine the
desired dimension for vertical height "B."
A
[
A
B
A. Vertical supports
B. Vertical height
Hood
Non-Vented
(recirculating)
Installation
1. Attach the air deflector to the upper horizontal support using
4 mounting screws.
A. Deflector
B. Mounting screws
2=
Measure the length of 6" (15.2 cm) duct needed to connect
the transition to the deflector.
NOTE: Vent should fit up inside the deflector 1" (2.5 cm)
minimum.
3. Install vent between the transition and the deflector.
NOTE: To make vent installation easier, temporarily
remove
the deflector from the chimney support bracket and replace
after vent section is in place.
4. Seal all connections
with vent clamps. Continue with "Range
Hood Installation"
in this section.
Range Hood Installation
1=
2=
Using 2 or more people, lift the range hood assembly and
attach it by snapping the vertical supports to the spring clips
in the upper horizontal support bracket that is mounted to the
ceiling.
Install 16 - 4 x 8 mm screws and tighten to secure.
____B
A ..........
A. Mounting screws
Connect Vent System
1. Install vent system.
2. Push duct over the exhaust outlet. Seal all connections with
vent clamps.
3. Use caulk to seal all openings.