Whirlpool UXT4030AYS0 Installation Instructions And Use & Care Manual - Page 4
Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood Whirlpool UXT4030AYS0. Whirlpool UXT4030AYS0 24 pages. 30" (76.2 cm) and 36" (91.4 cm) range hood installation instructions
Print Page
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
•
Drill
•
1V4" (3.0 cm) drill bit
•
1/8"(3.0 mm) drill bit for pilot holes
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Caulking gun and weatherproof
caulking compound
•
Flat-blade screwdriver
•
Phillips screwdriver
•
Saber or keyhole saw
Parts Supplied
•
T-10 Torx ®tadapter
•
T-20 Torx ®tadapter
•
4- 4.5 x 13 mm mounting screws
Parts Needed
•
3 - UL listed wire connectors
•
1 - 75W max, 120V incandescent
light bulb
For cabinets
with recessed
bottoms:
•
Two 2" (5.1 cm) wide filler strips. Length and thickness
determined by recess dimensions.
•
Four flat head wood screws or machine screws with washers
and nuts (to attach filler strips).
B}cc on
sme ' ils
IMPORTANT: Observe all governing codes and ordinances.
•
It is the installer's responsibility
to comply with installation
clearances specified on the model/serial rating plate. The
model/serial
rating plate is located inside the range hood on
the left wall.
•
Range hood location should be away from strong draft areas,
such as windows, doors and strong heating vents.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance. Consult the
cooktop/range
manufacturer
installation instructions
before
making any cutouts.
•
Grounded electrical outlet is required. See "Electrical
Requirements"
section.
•
All openings in ceiling and wall where range hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured
Home Construction
Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction
and Safety, title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured
Home
Installation 1982 (Manufactured
Home Sites, Communities
and
Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local
codes.
Product Dimensions
7/8"
:.2crn)
(16.7 cm)
1 it
(2.5crn)
415/16"
(12.5crn)
29_5/16"(76.0 cm) or
2W'
_/5.4
cm) 18%"
35Wld' (91.0 cm) _-____
_(47.3
cm)
I"®TORX is a registered trademark
of Saturn Fasteners,
Inc.