Whirlpool UXT52 Installation Instructions

Browse online or download pdf Installation Instructions for Ventilation Hood Whirlpool UXT52. Whirlpool UXT52 4 pages.

RANGE HOOD INSTALLATION INSTRUCTIONS

For questions about features, operation/performance, parts, accessories, or service, call: 1-800-253-1301.

Residential range hoods can be installed to comply with Sections 308 and 309 of ADA Guidelines when used with appropriately

mounted controls installed at 15" (38.1 cm) to 40" (101.6 cm) above the floor, and control access should not require reaching over

a cooking appliance.

The following range hoods can work in an ADA-compliant situation when the range hood is wired to operate from a dedicated

standard electrical wall switch. To facilitate this application, share the information on the following pages with your electrician

when preparing for the installation.

NOTE: All the models can be controlled only by one remote switch. The switch activates or deactivates the motor and the light

of the hood.

Two-Speed Range Hoods

(with rocker switch)

UXT20

■

UXT30

■

UXT40

■

UXT41

■

Tools and Parts

Tools Needed

Wire stripper

Parts Needed

UL Listed/CSA

Approved wire

connectors

UL Listed single pole

toggle light switch

W11108368A

FOR ADA COMPLIANCE

In Canada, for assistance, installation, and service, call: 1-800-607-6777.

UXT42

■

INSTALLATION REQUIREMENTS

#2 Phillips

Flat-blade

screwdriver

UL Listed #14

Approved

(minimum)

1/2" (13 mm)

3 wire cable

strain relief

UL Listed deep

single-gang

switch box

Intermediate Range Hoods

(with rotary switch)

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in

conformance with National Electrical Code, ANSI/NFPA 70

(latest edition), or CSA Standards C22.1-94, Canadian Electrical

Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local

codes and ordinances.

If codes permit and a separate ground wire is used, it is

recommended that a qualified electrician determine that the

ground path is adequate.

A copy of the above code standards can be obtained from:

A 120-volt, 60 Hz., AC-only, 15-amp fused electrical circuit

■

is required.

Three-Speed Range Hoods

(with push buttons)

UXT52

■

WVU37U

■

Electrical Requirements

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575