AER HEAD ONE Manual - Page 5
Browse online or download pdf Manual for Amplifier AER HEAD ONE. AER HEAD ONE 10 pages.
Print Page
Head one
Rear panel, from left to right
highpass
return
tuner
line
lowpass
send
tuner
Tuner output excluding tone control
or effects
line
Output, including Master with tone
controls, effect, stereo return of
external effects
highpass
At this output is a high-pass signal,
regardless of the operating mode of
the Head One.
lowpass
At this output is a low-pass signal,
regardless of the operating mode of
the Head One.
(When the 2-way mode is used,
a high-pass signal only is available all
loudspeaker outputs)
return
Return signal from external effect units
send
Sends the pre-amp signal to external
effects
return level
Controls the amount of return signal
from external effects
Par/ser switch
Select switch for external effects,
whether insert mode is in parallel or series
2 Channel Full-Range mode
Amp 1
Preamplifier
Amp 2
mode
par
2 channel
fullrange
return
out 3
ser
bridge
2 way active
level
out 1
CAB one
out 2
CAB one
-5-
out 2
out 1
mode:
full-range
see illustration
2 way active
see illustration
bridge mode
As a bridged amplifier for a higher output
level for use with a full-range cabinet
(only recommeded for use with an
8 Ohm cabinet)
out 3
Loudspeaker output (R
delivers full-range signal in bridge mode
out 2
Loudspeaker output (R
delivers full-range signal in Bridge Modus
or high-mid signal in 2-way-mode
out 1
Loudspeaker output (R
delivers full-range signal in Bridge Modus
or bass signal in 2-way-mode
powercon
Connection to mains
fuse
Fuse 6,3 Ampere
gnd
Protective earth conductor
2-Way-Active
Lowpass
Preamplifier
Highpass
fuse
powercon
gnd
= 8 Ohm)
min
= 4 Ohm)
min
= 4 Ohm)
min
out 1
Amp 1
CAB two
out 2
Amp 2
CAB one