CalderaSpas CalderaSpas Utopia Series Pre-Delivery Instructions - Page 3
Browse online or download pdf Pre-Delivery Instructions for Spa CalderaSpas CalderaSpas Utopia Series. CalderaSpas CalderaSpas Utopia Series 17 pages.
Also for CalderaSpas CalderaSpas Utopia Series: Pre-Delivery Instructions (16 pages)
Print Page
*NOTE: A reinforced concrete pad at least four inches thick or
structurally sound deck able to support the "dead weight" found in the
spa specification chart for each model (see back page).The reinforcing
rod or mesh in the pad should be attached to a bond wire.
•
Concrete sloped at 1/2 inch per 10 feet is preferred so that
rain water and water spillover will run off and not puddle
underneath the spa (water under the spa for long periods of
time may cause the wood to deteriorate).
•
If stepping stones or railroad ties are selected for the spa
foundation, they should be placed and leveled below the entire
spa to maintain even distribution of the spa weight.
•
It is important to note that soft surfaces, even when stepping
stones are used to distribute the weight of the spa as evenly
as possible, will still have a tendency to settle unevenly,
resulting in an unlevel spa.
•
Remember, placing the spa on grass or dirt may increase the
amount of debris which is inadvertently brought into the spa
water on the user's feet.
If you are purchasing a deck package or a spa enclosure with your spa,
a solid foundation becomes mandatory. Placing them on any surface other than a single level pad could create
problems with their installation. Pictured at right are a few of the recommended surfaces.
As a homeowner, it is your responsibility to provide a suitable, level foundation for your spa. Keep in mind that most
delivery crews are not equipped to level and prepare spa sites.
If you are interested in having a concrete slab, brick surface, or wood deck installed, your CALDERA dealer should
be able to suggest a qualified, licensed contractor.
DELIVERY ACCESS
First, locate the dimensions of your spa on the chart that is found on the next page. The dimensions shown are the
measurements of the spa in the vertical position, laid on its side.
Next, contact your dealer to find the height and width added by the delivery cart which the dealer will use to deliver
your new spa. Use the height of the cart plus the dimension shown as H to determine the vertical clearance required
to pass the spa and cart. Use the width of the cart, or dimension W, whichever is greater, to determine the maximum
width of clearance necessary. Use the length dimension L when making any sharp turns to determine the maximum
clearance required.
NOTE: It is strongly recommended to keep the spa in its original factory protective packaging particularly
when loading, moving or handling the spa in a vertical position. It may be necessary to allow for additional
over-head clearance if the spa will be rolled up or down an incline or moved up or down a short flight of stairs.
Use the information in the picture on next page to determine the requirements for access to your desired location.
It may be necessary to remove a gate, part of a fence, or other movable obstructions in order to roll the spa to
its installation site. About ten percent of the time, a crane is the only way to install the spa by lifting it to its final
destination.
If the spa has to be taken off of the cart to go over a wall (either because the entry area is too narrow, the eaves are
too low, the corner is too tight, or the stairway is too steep), a crane will be required. Don't be alarmed!
FOUNDATIONS FOR SPAS
WITH GAZEBOS
CONCRETE PADS
BRICK SURFACES
WOOD DECKING
Page 3