Caldertech Calderprep Plus Operating Instructions Manual - Page 7

Browse online or download pdf Operating Instructions Manual for Power Tool Caldertech Calderprep Plus. Caldertech Calderprep Plus 16 pages. Rotary scraping tool 20-63mm

Print Page

Operating Instructions

04.

Calderprep Plus Rotary Scraping Tool 20-63mm

Operation

Cutting Tip

Mandrel Shaft

Instructions for Use

1. Check the pipe size and SDR in order to select the correct Mandrel.

2. Unscrew the shaft thumbscrew by turning anticlockwise. It is not

necessary to fully remove this from the tool.

3. Use the shaft locator to locate the shaft at the correct position for

the pipe being used by lining up the line on the side of the shaft

locator with the size markings on the body of the tool then tighten

the shaft thumbscrew clockwise.

4. Ensure the arm spring clip is keeping the arm of the tool in its

uppermost position. If it is not, press on the rear of the arm with the

thumb and move the clip to keep the arm in its uppermost position.

5. Insert the mandrel shaft into the selected mandrel.

6. Insert the mandrel fully into the pipe to be scraped.

7. Turn the whole tool clockwise until the cutting tip is over the edge

of the pipe. Ensure it is on the edge to ensure there are no areas of

un-scraped pipe.

8. Push down on the rear of the arm and release the spring clip to

allow the cutting tip to rest on the pipe.

Arm Spring Clip

Shaft Locator

04. Operation

Shaft Thumbscrew