Fireside Furnishings Kenwood Installation Manual - Page 4

Browse online or download pdf Installation Manual for Fireplace Accessories Fireside Furnishings Kenwood. Fireside Furnishings Kenwood 6 pages. Wall cabinet

Print Page

Make sure the fireplace is installed according to local

codes.

In order to use the optional hearth base, the bottom of the

fireplace must have been installed 9-1/4" above the finished

floor level as shown above. The fireplace should sit in recess in

the optional base with front pulled against the front part of the

top.

Put the top (a) over the cabinet with the back of the top

resting on the ledger board.

Using an electric drill, predrill 1/16" holes down through the top

into the ledger board. The holes should be drilled 1/2" off of

the back edge of the top. Attach the top to the ledger board

using (2) 4D finishing nails (provided) through predrilled holes.

Use a nail set to set the nail head below surface of top, and fill

the resulting hole with an appropriate filler.

www.fireplaces.com

Set cabinet in it's final position, fireplace must be already

installed. The fireplace front should be 17-1/4" from the the wall

for SL-350, SL-550, SL-750 fireplaces and 20" from the wall for

ND3933, ND3630 fireplaces. Make sure that the face of the

fireplace and front surface of the marble cleats line up. Make

sure there is proper clearances around fireplace and enough

room for marble header and legs.

Using a stud finder or other method, mark off the location of the

vertical studs. Line up the top edge of ledger board with the top

edge of returns and attach ledger board to the wall using 2 #8 3"

drywall screws (h).

If you are not using non-combustible hearth or you are using

optional base, go to the next step.

Apply construction adhesive to bottom of hearth and install it on

the floor between cabinet the legs, pushed back against the fire-

place

KENWOOD-WALL-CAB

REV. 1

06.17.2009