Firestar vi30 Quick Start Manuals

Browse online or download pdf Quick Start Manuals for Measuring Instruments Firestar vi30. Firestar vi30 15 pages. Dual cooled laser

Print Page

Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide

Laser Unpacking:

Important

See your

Note:

tion details and instructions.

Read all

the (Laser Safety Hazard information) sections in the Laser's Operation Manual and in

our Laser Safety/Compliance 101 on our website.

Caution

Caution! Unpacking the wire harness incorrectly can lead to damage.

Possible

Keep All specially designed Foam Packaging and end-caps, you will need to re-use it

Equipment

when re-packaging/moving your laser. Refer to this guide and the Technical Reference

Damage

chapters in the laser's Operation Manual when re-packaging for shipping and/or reloca-

tion. Hint-if laser doesn't re-seat into the foam easily, try flipping it around 180 degrees.

Mounting feet and/or rails are optional, for complete details, refer to the laser's Operator's

drawings

and

Mounting Quick Start Guide

If you discover shipping damage, document the damage (photographically if possible), then immediately

notify the shipping carrier (responsible party) and SYNRAD. After unpacking, review the Inventory list in the

Intro section within the operators manual.

If you need a replacement box for packing and/or shipping your laser,

Caution! When re-packing the laser for relocation or shipment, use compressed shop air (less than 29

1. Unseat the wiring by sliding the harness out of

PSI) to blow out excess water from the cooling systems. Wear safety goggles! Nothing can be on the

the notch, then down and out of the foam as

sides of the laser at any time as damage will occur. There is only one way the laser fits into the foam! All

shown below.

components must be stowed under the laser. Re-package the wire harness as shown above. The wire

harness &/or ports can be damaged in shipping if not re-packaged as shown in this guide, the drawings,

Carefully push the wire harness through the notch in the top foam piece, and save with packaging.

operation manual, and/or resources located in our website.

Marking Head

(If utilized) and the

Danger,

Warning,

located on our website.

Hint:

laser's Operators Manual

Caution terms, symbols, and instructions located in

2. Remove the laser from the box and locate the

mounting hardware kit at the bottom of the

box under the laser.

Important Re-packaging Note:

Assure the two (2) H

the foam notches, & all residual water drained

from the system.

There is only one way the laser fits into the foam!

If laser does not reseat easily, try flipping it around

so the ports sit into the foam as shown.

vi30/40 Dual Cooled QSG Version 2.1

for complete installa-

Manual

and

contact

us.

O ports are nested inside