Clarion 28184-2Y000 Service Manual

Browse online or download pdf Service Manual for Car Receiver Clarion 28184-2Y000. Clarion 28184-2Y000 10 pages.

Print Page

■

SPECIFICATIONS

Sampling frequency:

Frequency response:

Signal to noise ratio:

Wow and flutter:

Power supply:

Current consumption:

Weight:

Specification and design are subject to change without

※

notice for further improvement.

■

COMPONENTS

PN-2144A-A/D-A

Main unit

Lock pin

PP-2144H-A/B

Main unit

Lock pin

■

NOTE

We cannot supply PWB with component parts in principle.

When a circuit on PWB has failure , please repair it by

component parts base. Parts which are not mentioned in

service manual are not supplied.

Clarion Co., Ltd.

Export Division - 22-3, Shibuya 2-chome, Shibuyaku, Tokyo, 150-8335 Japan

Service Dept.- 50 kamitoda,Toda-shi,Saitama,335 Japan Tel: 048-443-1111 FAX:048-433-6996

44.1kHz

5Hz to 20kHz (

1dB)

105dB (1kHz) IHF.A

below measurement limits

DC14.4V (10.8V to 15.6V)

negative ground

Less than 1A

3.8lb. (1.7kg)

−−−−−

331-2241-00

331-2241-10

−−−−−

331-2241-00

331-2241-10

Service Manual

NISSAN Automobile Genuine

6 DISC COMPACT CHANGER

PN-2144A-A

Model

(Genuine N0. 28184-4H000)

PN-2144D-A

Model

(Genuine N0. 28184-2Y000)

PP-2144H-A

Model

(Genuine N0. 28148-VB000)

PP-2144H-B

Model

(Genuine N0. 28148-VB700)

To engineers in charge of repair

■

or inspection of our products.

Before repair or inspection, make sure to follow

the instructions so that customers and Engineers

in charge of repair or inspection can avoid suf-

fering any risk or injury.

1. Use specified parts.

The system uses parts with special safety features

against fire and voltage. Use only parts with equivalent

characteristics when replacing them.

The use of unspecified parts shall be regarded as re-

modeling for which we shall not be liable. The onus of

product liability (PL) shall not be our responsibility in

cases where an accident or failure is as a result of un-

specified parts being used.

2. Place the parts and wiring back in their original positions

after replacement or re-wiring.

For proper circuit construction, use of insulation tubes,

bonding, gaps to PWB, etc, is involved. The wiring con-

nection and routing to the PWB are specially planned

using clamps to keep away from heated and high volt-

age parts. Ensure that they are placed back in their origi-

nal positions after repair or inspection.

If extended damage is caused due to negligence during

repair, the legal responsibility shall be with the repairing

company.

- 1 -

Published by Service Dept.

Tel: 03-3400-1121

298-5688-00 Sep.1998 P

Printed in Japan

PN-2144A / D

PP-2144H