Firetide HotPort 6101 Hardware Installation Manual - Page 7

Browse online or download pdf Hardware Installation Manual for Network Hardware Firetide HotPort 6101. Firetide HotPort 6101 20 pages. 6100 series
Also for Firetide HotPort 6101: Quick Installation Manual (2 pages)

Print Page

Indoor Node Installation

Indoor node installation is straightforward. Place the unit on a

Figure 1. AC Power Brick

table or shelf, or use the optional bracket to attach it to a wall, ceil-

ing, or cubicle partition. Attach the antennas, keeping in mind that

all antennas on all units should be parallel - typically vertical. Apply

power. The power LED should illuminate immediately; after about 60

to 90 seconds, the status LED should switch to steady green.

Firetide recommends that you power up and configure all nodes on

a table or bench before deployment. Use HotView or HotView Pro to

configure your mesh.

Figure . Optional Mounting Bracket

Note the location of the reset button in the lower right corner of the

rear panel. A paperclip can be used to reset the unit after it has fully

booted and the status light has come on.

Figure . HotPort 6100 Series Mesh Node - Front View

Figure . HotPort 6100 Series Mesh Node - Rear View

Firetide Instant Mesh Networks

February 2007