Firetide HotClient 2100 Hardware Installation Manual - Page 4

Browse online or download pdf Hardware Installation Manual for Wireless Router Firetide HotClient 2100. Firetide HotClient 2100 11 pages. Customer premises equipment

Print Page

Setup - Outdoor

Figure 3. Power-Feed Unit Connections.

ISP-Provided Technical Support

and Warranty Services

CPE Hardware Guide

If your ISP has chosen to use an outdoor HotClient, it will have been installed by a professional

installer. The installer will have provided a hard-wired Ethernet connection into your home or place

of business.

The Firetide HotClient does require power. Power is fed to it via the Ethernet cable. Connect the

power-feed unit to AC power. The ON light should turn green. Plug the cable from the HotClient

into the port marked OUT. The CONNECT light should turn green. If the FAULT light comes on, con-

tact your ISP.

Connect the device to your PC or home network via the RJ-45 connector. A crossover cable is NOT

required. Your Internet Service Provider has pre-configured your device. Set your computer to ob-

tain an IP address automatically (DHCP) and you can connect to the Internet.

Setup is now complete.

If you need additional technical assistance, please contact your ISP directly. Your ISP is trained

and authorized to provide technical support and warranty services for Firetide products and has

qualified technical staff available to help you configure and maintain your Firetide Internet Con-

nection.

December 2007