Ergo EMCTM-MS2 Installation Manual - Page 5

Browse online or download pdf Installation Manual for Racks & Stands Ergo EMCTM-MS2. Ergo EMCTM-MS2 9 pages. Flat panel display mount

Print Page
Phillips Head Screwdriver
DIMPLES
FACING UP
DIMPLES
FACING UP
Wall
Stud fi nder
Wood Stud
16"
16"
DIMPLES
FACING DOWN
DIMPLES
FACING DOWN
Dimples
M8
M6
M5
M4
16"
Viewing Height
Mark
Wall Plate
Flat Washer
Lag Bolt
Socket
Griplate™ Installation
The Griplate™ has M4, M5, M6 and M8 hole patterns
1
to fi t the hardware that your fl at panel requires.
2
Example: If your Plasma uses M8 x 20 Phillips screws
use the M8 Mounting hole on the Griplate™.
NB The upper Griplate™ must be mounted with the
dimples facing up. The lower Griplate™ must be
mounted with the fl at side facing up.
Pre-install two (2) M6 x 30mm Phillip pan screws to
1
the bottom of the left and right hand side mounting
brackets.
Once the mounting brackets are aligned secure the
2
Griplate™ to the fl at panel.

Wall Stud Location

Using a (commercially available) wood stud fi nder,
1
locate the 16" or 24" stud centres behind the wall.
Once found, make a pencil marking on the centre of
2
the wood studs.
Place the wall plate to the reference line and mark
3
the four (4) lag bolt mounting points through the
wall plate slots on the wall.
Level the wall plate with the reference arrow
4
pointing up to the ceiling.
Drill four (4) 1/4" pilot holes to the marked wall.
5
Secure the plate using the four (4) 5/16" lag bolts
6
and fl at washers.