3Com IntelliJack NJ200 Supplementary Manual - Page 10
Browse online or download pdf Supplementary Manual for Network Hardware 3Com IntelliJack NJ200. 3Com IntelliJack NJ200 14 pages. Network jacks
Also for 3Com IntelliJack NJ200: Software Manual (7 pages), Datasheet (4 pages)
Print Page
3 C O M
®
N J 2 0 0 N E T W O R K J A C K — V L A N S & T R A F F I C P R I O R I T I Z AT I O N
Figure 7. Traffic priority levels are individually
configured for each PAN port.
10
Configuring traffic priority levels is accomplished using 3Com Central Configuration
Manager:
1. Open 3Com
Central Configuration Manager
menu.
2. From the list of devices, select an NJ200 Network Jack and then select
You can also right-click on its IP address and select
3. Click on the
Priority
tab and select a PAN (device) port to configure. For example,
the configuration window for Port 2 will look similar to this:
4. Under
Priority Lookup Scheme
a) None
b) 802.1p Traffic Class fields
c) Use IP TOS, Diffserv fields
d) Both
To ignore the priority tags on incoming Ethernet frames, set the
Scheme
None
to
.
Note: Priority Lookup Scheme specifically instructs the NJ200/NJ205 to inspect Ethernet frames at the LAN
port for 802.1p, Diffserv, or both. If the incoming traffic will not be Diffserv or 802.1p, the Priority Lookup
Scheme should be set at "None."
5. Under
Default Priority Level
a) 802.1p Priority 0 or 1
b) 802.1p Priority 2 or 3
c) 802.1p Priority 4 or 5
d) 802.1p Priority 6 or 7
OK
6. Click
to exit the configuration window. Repeat these steps for the other PAN ports.
and select
Devices
Property
, choose one of the following settings:
, set what priority level to associate with the PAN port:
from the main
Property
.
from the menu.
Priority Look up