Ergo In Demand CrossRoads Assembly Instructions - Page 2

Browse online or download pdf Assembly Instructions for Indoor Furnishing Ergo In Demand CrossRoads. Ergo In Demand CrossRoads 2 pages. Newspaper display unit

Print Page
CrossRoads
Newspaper Display Unit
®
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
8. For optional back panel, slide the back
panel into the side grooves of the end
panels and top assembly. Insert #8 x
/
" screws into the groove directly
5
8
below the back panel to keep the panel
raised o the oor (Figures 5 & 6).
9. Carefully tip the shelving unit into an
upright position. Note that two or
more assemblers are recommended
when multiple units are connected.
10. Bottom shelf. Insert (4) metal pegs
into pre-drilled holes just above the
base assembly. Lay bottom shelf with
routed side down and align onto metal
pegs (Figure 7).
11. Attach wood cleats to the bottom side
of the xed shelf using #8 x 1
One cleat is needed for each side of
shelf. Rest shelf on four metal pegs.
Attach xed shelf with cleats to the
end panels using #8 x 1
/
" screws
1
4
(Figur e 7). Note: for 60" high units,
xed shelf is approximately 43
top of the bottom shelf. For 82" high
units, xed shelf is approximately 50
from top of the bottom shelf.
12.Adjustable shelves for 82" high units
only . Insert (4) metal pegs into pre-
drilled holes at desired adjustable
shelf heights. Set each shelf onto the
metal pegs with routed side down.
Repeat for each adjustable shelf
(Figure 7).
13.Attach notched rack to panels using
two #10 x 1
/
" screws. Note: for 60"
1
2
high units locate upper screw 36
above bottom shelf and 1
/
5
back panel. For 82" high units, locate
upper screw 44
/
"above bottom shelf
3
4
and 1
/
" from back panel. Align the
5
8
bottom of the rack with the front edge
of the shared panel or 1" in from the
center of the arc of the end panels.
Attach with #10 x 1
/
" screw.
1
2
14. Set up to eight newspaper display
rods into notched racks.
Figure 5
/
" screws.
1
4
Back Panel
/
" from
1
4
/
"
13
16
Figure 6
/
"
3
4
" from
8
Right End Panel
Base Assembly
Glides (2)
5
#8 x
/
"
Right End Panel
8
Support Screws (2)
Base Assembly
Glides (2)
Figure 5 & 6
#8 x
5
/
"
8
Support Screws (2)
Back Panel
Shelf Back Inst.eps
Figure 7
Ergo In Demand, Inc.
4900 Industry Drive
Central Point, OR 97502
Contact Information:
800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
www.ergoindemand.com (Website)
Side Groove
Back Panel
Fixed Shelf
Figure 5 & 6
(4 per Shelf)
Shelf Back Inst.eps
(2 per Shelf)
#10 x 1
1
/
"
2
Pan Head Screws
(4 per Shelf)
Base Assembly
Bottom Shelf
Side Groove
Back Panel