Clarion EF-1080I-C Service Manual
Browse online or download pdf Service Manual for Amplifier Clarion EF-1080I-C. Clarion EF-1080I-C 9 pages. Subaru automobile genuine power amplifier
Print Page
■
SPECIFICATIONS
Main section
Gain:
FRONT 23dB
REAR 24dB
Power output:
35W
More than 20W
(100Hz
Distortion(THD):
Less than 0.05
(0.5W output,1kHz)
S/N ratio:
More than 80dB(1kHz)
Load impedance:
8
Sub woofer section
Gain:
29dB
Power output:
60W(maximum)
More than 40W
(50Hz,THD0.05%,4
Distortion(THD):
Less than 0.08
(0.5W output,50Hz)
S/N ratio:
More than 80dB(50Hz)
Load impedance:
4
General
Channel separation:
More than 60dB(1kHz)
Power supply voltage: DC14.4V(10.8V to 15.6V)
Current consumption: Less than 25A
Dimensions(mm):
240(W)
Weight:
2.3kg
Specifications and design are subject to change without
※
notice for further improvement.
Clarion Co., Ltd.
22-3, Shibuya 2-chome, Shibuyaku, Tokyo, 150-8335 Japan
Service Dept.- 50 kamitoda,Toda-shi,Saitama,335-8511 Japan Tel: 048-443-1111 FAX:048-433-6996
±
2dB(1.5kHz)
2dB(500Hz)
±
4ch(maximum)
×
4ch
×
15kHz,THD0.05%,8
∼
Ω
％
Ω
±
2dB(30Hz)
Ω
)
％
Ω
50(H)
165(D)
×
×
Service Manual
SUBARU Automobile Genuine
Power Amplifier
EF-1080I-C
Model
(Genuine No.86221AE02A)
■
NOTE
We cannot supply PWB with component parts in principle.
When a circuit on PWB has failure,please repair it by com-
ponent parts base.Parts which are not mentioned in service
manual are not supplied.
COMPONENT
■
)
EF-1080I-C
Main unit
■
To engineers in charge of repair or
inspection of our products.
Before repair or inspection, make sure to follow
the instructions so that customers and Engineers
in charge of repair or inspection can avoid suf-
fering any risk or injury.
1. Use specified parts.
The system uses parts with special safety features against
fire and voltage. Use only parts with equivalent charac-
teristics when replacing them.
The use of unspecified parts shall be regarded as re-
modeling for which we shall not be liable. The onus of
product liability (PL) shall not be our responsibility in cases
where an accident or failure is as a result of unspecified
parts being used.
2. Place the parts and wiring back in their original positions
after replacement or re-wiring.
For proper circuit construction, use of insulation tubes,
bonding,gaps to PWB, etc, is involved. The wiring con-
nection and routing to the PWB are specially planned
using clamps to keep away from heated and high voltage
parts. Ensure that they are placed back in their original
positions after repair or inspection.
- 1 -
Published by Service Dept.
298-5891-00 Jan.2001 P
Printed in Japan
−−−−−
1
EF-1080I-C