AerAtron AE3+50 User Manual & Installation Manual - Page 14

Browse online or download pdf User Manual & Installation Manual for Fan AerAtron AE3+50. AerAtron AE3+50 18 pages.

Print Page

Care and Cleaning

Regular cleaning of the Aeratron Ceiling fan blades and fan motor housing is the only maintenance needed.

Due to the self-balancing design, a large build up of dust on blades may create an imbalance in extreme cases

only, causing the blades to wobble during use. This is likely to be more apparent on fans with an extension rod.

Regular cleaning of the blade is recommended to prevent dust from building up.

1. When cleaning your fan, only use a soft brush or lint free cloth to avoid scratching the ﬁnish. DO NOT

use water when cleaning your ceiling fan. It could damage the motor or blades and/or create the

possibility of electric shock.

2. When dusting the blades, they must be supported to prevent bending - no pressure should be applied

to the blade pivot. After cleaning the blades, check to ensure that the Drive Shaft is vertical, otherwise

the fan may wobble.

3. Occasionally, it may be necessary to re-tighten the fan blades/screws to prevent any clicking or

humming sounds during operation. This is especially true in climates with broad temperature and

humidity ranges.

4. If you experience any ﬂaw in the operation of your fan, please check the points in the Trouble Shooting

section below.

Except for items 1 to 3 below, the following require access to

areas of the fan which carry lethal voltage and must be carried

out by properly qualiﬁed personnel. ONLY points 1 to 3 below

can be carried out by the user.

If the fan does not operate properly, or turns on or oﬀ at random.

1. If applicable, change the batteries in the Remote Control (Handset).

2. Re-pair the remote using steps 3&4 (page 7)

3. Multiple fans: disconnect power to all fans, wait for a minimum of 10 seconds before switching

power back on to all the fans (see page 7)

4. Disconnect and reconnect the 3-pin connector (receiver to motor) to make sure that the

connectors are fully engaged (see page 6)

5. Check the main and branch circuit breakers and/or fuses.

6. Check the wire connections to the fan.

7. Other RF devices may obstruct the handset to receiver signal.

8. Check to make sure that Suspension Ball is located in the slot correctly, and the one screw

securing the suspension ball is tight (see page 5).

9. Check that Hanger Bracket is solidly mounted, no movement allowed (see page 4)

10. Check that the 2 Hub screws per fan blade are tight and ﬁrm (see page 8)

11. Excess wind can lift the fan blades and result in some noise.

If the fan rotates but does not create much airﬂow

12. The room may contain items which obstruct the air-ﬂow.

13. The fan may be too small for the size of the room.

14. The fan might be in reverse function (counter clockwise rotation)

Note: In some areas, signals are sent through the power lines by the electricity supplier for the control of

oﬀ peak hot water, street lights and so on. These signals may cause an intermittent humming in the ceiling

fan. Filters may be available in your country at customer costs. It is not a ceiling fan fault.