AerAtron E503 User Manual & Technical Specifications - Page 16

Browse online or download pdf User Manual & Technical Specifications for Fan AerAtron E503. AerAtron E503 20 pages.

Print Page

AerAtron >> Silent Efficiency

Care & Cleaning

Regular cleaning of the Aeratron Ceiling fan blades and fan motor housing is the only maintenance

that is needed. Due to the self‐balancing design, a large build up of dust on blades may only in

extreme cases create an imbalance, causing the blade to wobble during use. This is likely to be more

apparent on fans with a extension rod.

Regular cleaning of the blade is recommended to prevent dust from building up.

1. When cleaning your fan, only use a soft brush or lint free cloth to avoid scratching the finish.

DO NOT use water when cleaning your ceiling fan. It could damage the motor or blades and/or

create the possibility of electric shock.

2. When dusting the blades, you must support the blades to prevent bending ‐ no pressure

should be applied to the blade pivot. After cleaning the blades, check to ensure that the Drive

Shaft is vertical, otherwise the fan may wobble.

3. Occasionally, it may be necessary to re‐tighten the fan blades and fan motor housing fixing

screws to prevent any clicking or humming sounds during operation. This is especially true in

climates with broad temperature and humidity ranges.

4. If you experience any flaws in the operation of your fan, please check the points in the Trouble

Shooting section below.

WARNING: Except for items 1 and 2 below, the following require access to areas of the fan

which carry lethal voltage. There are no other checks which can be carried out by the user.

Apart from items 1 and 2, the following must be carried out by properly qualified personnel.

If the fan does not operate properly, or turns on or off at random.

1. If applicable, change the battery in the Remote Control Transmitter (Handset).

2. The room may contain items which obstruct the air flow.

3. The fan may be too small for the size of the room.

4. Reset code match (see page 13)

5. Check the main and branch circuit breakers and/or fuses.

6. Check the wire connections to the fan.

If the fan is noisy.

1. Check to make sure that the screws securing the Suspension Ball, Fan Motor Housing and Fan

Blades are tightened securely (see pages 9 and 12).

2. Check that all the screws in the Hanging Bracket are tight.

Note: In some areas, signals are sent through the power lines by the electricity supplier for the control

of off peak hot water, street lights and so on. These signals may cause an intermittent humming in the

ceiling fan. Filters are available in Australia at customer cost. It is not the fault of the ceiling fan.

If the fan rotates but does not create much airflow

1. The room may contain items which obstruct the air flow.

2. The fan may be too small for the size of the room.

General Information

1. All electrical motors, including fan motors make some noise, and may feel hot to the touch.

This is NOT a fault.

2. Ceiling fans tend to move during operation due to the fact that they are not rigidly mounted.

(Rigid mountings can generate excessive vibration and stress on the mountings). Movement of

IF THERE ARE ANY PROBLEMS DURING INSTALLATION OF THE FAN, THE INSTALLER MUST CONTACT THE AERATRON

HELP LINE BEFORE LEAVING THE SITE: SWISS PRECISION +61 410 465 228

Installation - Operation – Maintenance - Warranty