CALEFFI altecnic SATK102 Installation, Operation & Maintenance Instructions Manual - Page 2

Browse online or download pdf Installation, Operation & Maintenance Instructions Manual for Recording Equipment CALEFFI altecnic SATK102. CALEFFI altecnic SATK102 12 pages. Heat interface unit

Print Page
SAT102
heat interface unit
SATK102
Function
SATK102 Heat Interface Units (HIU) control the domestic hot
water generation in an individual apartment within a centralised
boiler or district heating system.
Wall mounted unit.
NOTE:
Due to the specification ordered, or the country of
destination, the actual unit may differ from those shown.
ontent
C
Function and product range
Safety instructions
Technical specification
Dimensions and components
Installation
Filling the primary heating system
System start up
Energy meter installation
Electronic controller
Dip switch settings
Safety and alarms
Maintenance
Electric connections
Trouble shooting and solution
Product Range
SATK10253
SATK10203
SATK10203HE
SATK10254
SATK10204
SATK10204HE
SATK10255
SATK10205
SATK10205HE
Safety Instructions
WARNING
These instructions must be read and understood
before installing and maintaining the HIU.
CAUTION! FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN A SAFETY
HAZARD!
1
The device must be installed, commissioned and
maintained by qualified technical personnel in accordance
with national regulations and/or relevant local
requirements.
2
If the device is not installed, commissioned and maintained
correctly in accordance with the instructions provided in
this manual, it may not work correctly and may endanger
1
the user.
1
3
Flush the pipework thoroughly before installing the HIU to
2
remove any particles, rust, incrustations, limescale, welding
3
slag and any other contaminants.
4
The water circuits must be clean and free from debris.
4
4
Make sure that all connection fittings are watertight.
4
5
When connecting water pipes, make sure that threaded
connections are not mechanically overstressed. Over time
5
this may result in breakage, causing water damage and/or
5
personal injury.
5
6
Water temperatures higher than 50˚C may cause severe
6
burns. When installing, commissioning and maintaining the
7
device, take the necessary precautions so that these
9
temperatures will not be hazardous for people.
10
7
In the case of particularly hard or impure water, there must
be suitable provision for filtering and treating the water
before it enters the device, in accordance with current
legislation. Failure to do so may result the HIU becoming
damaged or working incorrectly.
8
Any use of the HIU other than it's intended use is
prohibited
1
40 kW plate heater exchanger.
40 kW plate heater exchanger and primary
pump.
40 kW plate heater exchanger and high
efficiency primary pump.
70 kW plate heater exchanger.
70 kW plate heater exchanger and primary
pump.
70 kW plate heater exchanger and high
efficiency primary pump.
80 kW plate heater exchanger.
80 kW plate heater exchanger and primary
pump.
80 kW plate heater exchanger and high
efficiency primary pump.