Caleido SP1 Technical Manual - Page 6

Browse online or download pdf Technical Manual for Heater Caleido SP1. Caleido SP1 6 pages.

NOTES

- 1. When the thermostat is switched on again after a power failure, it returns to the last mode set, with the exception of 2h boost mode and Chrono.

The status of the thermostat is saved a few seconds after the last function activated.

- 2. To indicate that the remote control signal has been received, the device emits a beep by way of a beep.

- 3. The device may not detect the opening of a window.

This can happen when the thermostat is in an isolated location away from draughts or close to a heat source other than the device, or if the

change in ambient temperature is too slow.

- 4. Mode LED flashing amber: Probe failure, the device is deactivated.

- 5. When the lower LED is red, the radiator is in operation (heating up); when it is green, it is not heating up.

- 6. With the CHRONO function, it is important to set daytime temperatures to maximum and night-time temperatures to minimum.

- 7. The CHRONO function cannot be activated at the same time as the COMFORT/NIGHT functions.

DISPOSAL

This appliance is NOT normal household waste. It must be disposed of through the appropriate recycling points. In the event of

replacement, it can be returned to your distributor.

This end-of-life management will enable us to preserve our environment and curb the consumption of natural resources.

This symbol applied to the product indicates the obligation to deliver it to a special waste

collection centre for disposal in compliance with Directive 2002/96/EC (WEEE).

The manufacturer reserves the right to make any changes it deems necessary to

improve its product at any time without prior notice.

Repairs must be carried out by authorised personnel to avoid invalidation of the warranty

CALEIDO srl . via Pablo Neruda, 52/a . 25020 Flero (BS) . Italy

Tel +39 030 2530054 - Fax +39 030 2530533

caleido.it