Xerox 4150 - WorkCentre B/W Laser Getting Started Manual - Page 13

Browse online or download pdf Getting Started Manual for All in One Printer Xerox 4150 - WorkCentre B/W Laser. Xerox 4150 - WorkCentre B/W Laser 38 pages. Mfp
Also for Xerox 4150 - WorkCentre B/W Laser: Brochure & Specs (4 pages), Evaluator Manual (24 pages), Quick Reference (1 pages), Cartridges Replacement (1 pages), Installation Instructions Manual (40 pages), Module Installation Manual (1 pages), Hardware Installation Manual (1 pages), Tray Module Installation Manual (1 pages), Module Installation Manual (1 pages), Installation Manual (6 pages), Competitive Comparison (4 pages), Secure Installation And Operation (4 pages), Service Manual (13 pages)

Print Page

Connecting to the Network

If your WorkCentre is a 4150s, 4150x or 4150xf, follow these instructions to connect the

WorkCentre to an Ethernet TCP/IP network.

If you are connecting your WorkCentre to a different type of network, or you wish to use

other protocols, refer to the System Administration CD.

Test the WorkCentre

Before connecting the WorkCentre to your network, make sure that it is operating correctly

as a copier.

Place a document in the Document Feeder and make 3 copies.

If the copies are made successfully, install the network connection as described in the next

steps. If copying is not successful, refer to Troubleshooting on page 31.

Network Connection using TCP/IP

You can set up the TCP/IP network connection using either of the following methods:

• DHCP: Use this method to allow a DHCP server to automatically assign an IP address.

This is the factory default setting.

• Static IP address: Use this method to manually assign an IP address provided by the

network administrator.

When the WorkCentre is powered on, it automatically uses DHCP to obtain its network

configuration. To use a static IP address, DHCP must be turned off and the IP address,

gateway address, subnet mask, and DNS Server address must be entered manually.

Connect the Ethernet cable to the RJ45 connector

on the WorkCentre.

NOTE:

The Ethernet cable is not supplied by Xerox.

Continue on to the next step to setup the address

using DHCP. If you want to set a static IP address,

skip to Network Setup Using a Static IP Address on

page 10.

Network Setup Using DHCP

After the WorkCentre starts, it negotiates with the DHCP server for an IP address. Wait two

minutes for the network setup to complete and then check the allocated IP address as

follows:

• On the Control Panel, select the Access button and then enter the Administrator

passcode [1111] and select Enter.

• Select Go to Tools > Connectivity and Network Setup > Network Setup > TCP/

IP Options > TCP/IP Settings.

• The allocated TCP/IP address is in the Name/Address field.

getting started guide

RJ45

Network

Connector