Xerox 4150 - WorkCentre B/W Laser Getting Started Manual - Page 19

Browse online or download pdf Getting Started Manual for All in One Printer Xerox 4150 - WorkCentre B/W Laser. Xerox 4150 - WorkCentre B/W Laser 38 pages. Mfp
Also for Xerox 4150 - WorkCentre B/W Laser: Brochure & Specs (4 pages), Evaluator Manual (24 pages), Quick Reference (1 pages), Cartridges Replacement (1 pages), Installation Instructions Manual (40 pages), Module Installation Manual (1 pages), Hardware Installation Manual (1 pages), Tray Module Installation Manual (1 pages), Module Installation Manual (1 pages), Installation Manual (6 pages), Competitive Comparison (4 pages), Secure Installation And Operation (4 pages), Service Manual (13 pages)

Print Page

Installing Option Kits

This section provides instructions on how to install and configure optional features:

• Network Scanning

• Hard Disk Overwrite

• Server Fax

• Network Accounting

NOTE:

For instructions on installing and configuring Server Fax and Network Accounting,

refer to the System Administration CD.

Installing Option Kits

All the Option Kits are installed in the same way. Each kit will contain a Feature Enablement

Key and instructions.

With the WorkCentre switched on, insert

the Feature Enablement Key into the Card

Reader slot just above the On/Off switch on

the left hand side of the machine.

When the feature is successfully installed a

pop-up message will tell you that the

feature is configured and ask you to

remove the Feature Enablement Key.

Network Scanning

Network Scanning is an optional feature, available for the WorkCentre 4150s, 4150x and

4150xf, and can be purchased from your Xerox Sales Representative.

Network Scanning enables you to convert your hard copy documents to electronic files and

retrieve them from a server or workstation on the network.

There are two ways to configure Network Scanning:

• Use Internet Services, the WorkCentre's embedded web server, to set up the

Network Scanning feature. Installation and setup of this feature is described below.

• FreeFlow™ SMARTsend™ is an optional application that will scan to a variety of

destinations. Installation and setup of this feature is described in the FreeFlow™

SMARTsend™ System Administrators CD that comes with the application.

NOTE:

Scanning services should be enabled on your network before you enable the

Network Scanning option.

Install Internet Services Network Scanning

Configure the option. Refer to Installing Option Kits on page 15

Create a Network Scanning Repository

At your PC, open your web browser and enter the Host Name or IP address of the

WorkCentre.

Select Properties > Services > Network Scanning > File Repository Setup.

getting started guide

Card Reader

slot