Xerox DC230ST Quick Install
Browse online or download pdf Quick Install for All in One Printer Xerox DC230ST. Xerox DC230ST 2 pages. Xerox document centre 220: supplementary guide
Also for Xerox DC230ST: Quick Install Manual (8 pages), Scanning Overview (2 pages)
![Xerox DC230ST Quick Install](/uploads/products/server2/7033883/7033883.png)
Installation Requirements:
To install the DC220/230 into a DHCP environ-
ment, exclude the addresses assigned to the
DC220/230 at the DHCP server.
Before Installation:
Record the following information for use during
setup at the DC220/230:
TCP/IP:
TCP/IP Address:_________________________
Gateway Address:_______________________
Subnet Mask:_________________________
Broadcast Address:______________________
Host Name:_____________________________
NetBIOS:
Host Name:_____________________________
Printer Name:___________________________
Workgroup:_____________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
All manuals and user guides at all-guides.com
The Document Company
DC220/230ST Windows NT
1.
Connect the DC220/230 to your network
outlet or cable.
2.
Enter System Administration Setups:
a)
Press the [Access] button on the
Control Panel.
b)
Enter the System Administrator
password by typing
(# key and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
password and may be changed by
your Xerox service representative to
suit your needs.
c)
On the screen display, press [Print
Setups].
d)
Press [Network Setups].
Note: If TCP/IP has been installed, go to
step 4. If TCP/IP has not been installed,
continue with step 3.
3.
Access the TCP/IP Network Setups
screens:
a)
Press [TCP/IP].
XEROX
®
4.0 NetBIOS/IP Quick Install
#22222
b)
IP Address setup (skip this step if
using
RARP): Press [IP Address],
then press [Edit] and use the key-
board on the display screen to enter
the static IP address for the DC220/
230. This number is assigned by the
System Administrator
OR
b)
RARP setup (skip this step if using
a static IP
address): Press [RARP],
then press [Enabled].
c)
Press [Save].
d)
Press [Gateway Address], then press
[Edit] and use the keyboard on the
display screen to enter the Gateway
address of your network.
e)
Press [Save].
f)
Press [Subnet Mask], then press
[Edit] and use the keyboard on the
display screen to enter the Subnet
Mask for your network (default is
255.255.255.0).
g)
Press [Save].