Xerox Document Centre 230 Install Manual
Browse online or download pdf Install Manual for All in One Printer Xerox Document Centre 230. Xerox Document Centre 230 2 pages. Xerox document centre 230: install guide
Also for Xerox Document Centre 230: Quick Install (1 pages), Scanning Overview (2 pages), Quick Install Manual (8 pages), Getting Started (48 pages)
![Xerox Document Centre 230 Install Manual](/uploads/products/server2/7034131/7034131.png)
Before Installation:
Record the following information for use during
setup at the DC230LP:
AppleTalk Printer Name:___________________
Note: The DC230LP will attach itself to the
default zone of the local segment where it is
connected.
This installation procedure assumes that you
know how to navigate through the menu system
on the DC230LP Control Panel. Refer to the
quick reference card, Using the Menu System,
(701P96834) for assistance.
1.
Connect the DC230LP to your network
outlet or cable.
2.
Access the System Administration menus:
a)
Press [Online] to take the printer off
>
Printer Off Line
line.
displays.
Main Menu
b)
Press [Menu].
displays.
c)
Press [
], then press [ ] or [ ] until
>
System
displays.
Administration
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
DC230LP AppleTalk
d)
Press [
e)
Use the [ ] and [
[2222].
Note: 2222 is the factory default password and
may be changed to suit your needs. Refer to the
DC230LP System Administration Guide,
Network Installation and Troubleshooting .
f)
Press [Enter].
displays.
3.
Access the AppleTalk menus:
a)
Press [
b)
Press [ ] until
displays.
c)
Press [
d)
Press [ ] until
displays.
>
®
Quick Install
>
Enter Password
].
displays.
] keys to enter
>
System Admin
>
Port Setup
].
displays.
>
Network Setup
>
TCP/IP
].
displays.
>
AppleTalk
Page 1 of 2
4.
Enable AppleTalk
Enablement
a)
Press [
].
Disabled
Enablement
b)
Press [
].
Disabled
Enablement
c)
Press [ ].
Enabled
d)
Press [Enter]. **SAVED** is
displayed momentarily, followed by
>
Enablement
.
Enabled
5.
Enter the Printer Name:
Printer Name
a)
Press [ ] until
(current entry)
displays.
Printer Name
b)
Press [
].
(current entry)
c)
Press [
] repeatedly until the cursor
reaches the end of the entry. A tone
sounds indicating when the last
character has been reached.
>
displays.
=
displays.
*
=
displays.
>
=
displays.
*
Over