Xerox 460 Quick Install Manual - Page 10
Browse online or download pdf Quick Install Manual for Copier Xerox 460. Xerox 460 38 pages. Macintosh driver information
Also for Xerox 460: Information Manual (13 pages)
Print Page
DHCP / BOOTP Dynamic IP Address Assignment Quick Install Card
Xerox Document Centre 460/470 ST
8.
Press the Close button.
a)
Press the Dynamic Addressing
button. At the next screen select
DHCP or BOOTP and press Save.
9.
Enable lp and lpr printing (Skip steps 9a-
9b if you DO NOT wish to print to your
Document Centre using lp or lpr.
a)
Press the TCP/IP - Line Printer
button. At the next screen press the
Enable button.
NOTE: While you can change the port num-
ber at which your Document Centre
will accept lpr print jobs it is recom-
mended that you do this ONLY with
extreme caution as most lpr spoolers
are set to send print jobs to the default
port.
b)
If you wish to change the lpr port for
your printer press the port soft button
and enter the desired port number at
the keypad. Press Save.
c)
Press the Close button.
10.
Press the Exit Tools button.
NOTE: Your Document Centre will not reboot
unless you have changed a physical
media setting (Ethernet or Token
Ring).
11.
Wait a MINIMUM of 7 minutes for the
printer to reset.
a)
Obtain a Configuration Report page
from your printer. Verify the TCP/IP
information was assigned correctly.
b)
Update the lease time (if necessary) at
the DHCP/BOOTP server depending
on your printer usage patterns.
Consult your DHCP server
documentation for details.
Page 2
Where to go from here
After you have verified that the TCP/IP
information you have assigned to your
Document Centre is correct, retrieve the Quick
Install Card that applies to your network
operating system or protocol and perform the
procedures indicated.