Xerox 470 Quick Install Manual - Page 24
Browse online or download pdf Quick Install Manual for Copier Xerox 470. Xerox 470 38 pages. Macintosh driver information
Also for Xerox 470: Information Manual (13 pages)
Print Page
Microsoft Windows (NetBEUI) Peer-to-Peer Networks Quick Install Card
Xerox Document Centre 460/470 ST
d)
Press the Connections button.
7.
Set Maximum Connections and Timeout
a)
Touch the Maximum Connections
soft button on the Touch Screen and
using the keypad enter the desired
maximum connection number
between 1 and 30. It is recommended
that this value should be set at the
default.
b)
Touch the Connection Timeout soft
button on the Touch Screen. On the
keypad enter the desired number of
second between 0 and 9999. Press
Save to exit the Connections Screen.
8.
Exit the Tools Menu
a)
Press the Exit Tools button.
9.
Prepare for print driver installtion
10.
Obtain a Configuration Report from the
printer to use in the remainder of the
installation.
11.
From the documentation package supplied
with your printer, retrieve the CentreWare
Network Services CD-ROM and the
document entitled Network Services
Guide. Proceed to the next section of this
procedure called Go to the workstations
and.
Go to the workstations and...
1.
Verify that the NetBEUI protocol is loaded
(ALL Windows 3.11 or greater versions).
2.
Use the CentreWare Network Services
CD-ROM to install print drivers on a
Windows-based workstation. Details for
this are found in the document supplied
with your printer entitled Network
Services Guide.
3.
On the Configuration Report review the
NetBIOS: area and note the Workgroup,
Host Name, and Printer Name.
Windows for Workgroups Users
•
Open the Control Panel and double-click
the Printers icon.
•
Select the printer driver you just installed
and click Connect.
•
Select an available port and click Network.
•
Double-click the name of the WorkGroup for
the printer.
•
Double-click the Host Name of the printer.
•
Click once on the Printer Name then click
OK.
Page 2
Windows 95, Windows 98 and Windows
NT 4.X Workstation Users
•
Click the Start button and select Settings.
•
From the cascade menu select Printers.
•
Select a printer with the right mouse button.
•
Select the Properties entry in the cascade
menu.
•
Select the Details tab on the Properties
dialog.
•
Click the Add Port button and browse to the
Workgroup.
•
Double-click the name of the WorkGroup for
the printer as shown on the Configuration
Report.
•
Double-click the Host Name of the printer as
shown on the Configuration Report.
•
Click once on the Printer Name then click
OK.
4.
Open an application and print a test page
to verify operation.
5.
If your print job does not print, refer to the
Troubleshooting section of the Network
Installation and Troubleshooting Guide
to solve the problem.