Xerox M123 WorkCentre Quick Network Setup Manual - Page 5

Browse online or download pdf Quick Network Setup Manual for Copier Xerox M123 WorkCentre. Xerox M123 WorkCentre 7 pages. Stand installation guide
Also for Xerox M123 WorkCentre: Installation Manual (2 pages), Evaluator Manual (12 pages), Brochure & Specs (6 pages), Install Manual (2 pages), Network Manual (50 pages), Scan Manual (28 pages), Quick Installation Card (2 pages), Manual (28 pages), Office Finisher Installation Manual (6 pages), Office Finisher Installation Manual (6 pages), Hardware Installation Manual (4 pages), High Capacity Tray Installation Manual (3 pages), High Capacity Tray Installation Manual (3 pages), Hard Drive Kit Installation Manual (2 pages), Inverter Installation Manual (2 pages), Installation Manual (2 pages), Hardware Installation Manual (2 pages), Stand Installation Manual (2 pages), Reference Manual (20 pages), Service Manual (22 pages)

Print Page
Xerox M123 WorkCentre Quick Network Setup Manual
Figure 1
N
:
OTE
CentreWare Internet Services is a powerful tool for configuring the M123/M128 device
remotely. The default user name is "x-admin" and password is "11111". These should be changed
.
after install
Step 4
: Load the Print Drivers on the workstations that will be accessing the M123/M128 device.
For more detailed instructions, see the System Administrator Guide.
Q
u
i
c
k
N
e
t
w
o
r
k
S
e
t
u
p
(
S
t
a
t
i
c
I
P
)
Q
u
i
c
k
N
e
t
w
o
r
k
S
e
t
u
p
(
S
t
a
t
i
c
I
P
)
For: WorkCentre M123/M128 WorkCentre Pro 123/128
Pre-requisite for manual setup of network using Static IP Address:
Note that on startup the M123/M128 Multifunction device defaults to DHCP to obtain its network
configurations, so DHCP must be turned off by manually entering a Static IP
Before installing, record the following information for use during setup:
TCP/IP Address:
Gateway Address:
Subnet Mask:
DNS Server Address:
To obtain this information contact your System Administrator.
QNS
Page 5 of 7
701P42078