Xerox WorkCentre 133 Network Manual - Page 3

Browse online or download pdf Network Manual for Copier Xerox WorkCentre 133. Xerox WorkCentre 133 50 pages. Xerox copycentre 133: network guide
Also for Xerox WorkCentre 133: Brochure & Specs (6 pages), Install Manual (2 pages)

Print Page
Quick Network Setup Guide
This guide includes instructions for:
■
Quick Network Setup (DHCP)
Quick Network Setup (Static IP)
■
Quick Network Setup (DHCP)
The System Administrator Guide contains detailed information about network setups. This document is
intended for setting up the network using TCP/IP. If using Novel IPX, see the System Administrator Guide
for setup procedures.
Prerequisites for Quick Network Setup Using TCP/IP
1.
Confirm that an existing operational network utilizing TCP/IP is available.
2.
Confirm that the Ethernet cable is plugged into the multifunction device and into an operational Ethernet
port on the network.
Note
The Ethernet cable is an RJ45 type and is not supplied by Xerox.
Configuring an IP Address via DHCP
On startup, the multifunction device defaults to DHCP to obtain its network configurations. A DHCP server
delivers an IP address, as well as other configuration settings to the device. If you use a DHCP server to
allocate an IP address to the device, then proceed as follows:
Procedure for Quick Network Setup Using TCP/IP
1.
Power on the device.
2.
Wait a minute or so while the device negotiates an IP address.
3.
Print the System Settings List.
a.
Select the Machine Status button on the device.
b.
Select
Print Report
c.
Print Mode
Select
d.
Select
Setting List - Common
e.
Press the Start button.
Copyright © 2005, 2004 Xerox Corporation. All rights reserved.
on page 1
on page 3
List.
Settings.
Items.
Xerox WorkCentre
Xerox WorkCentre
1
®
M123/M128/133
®
Pro 123/128/133