Xerox WorkCentre M118 Remanufacturing Instructions - Page 2

Browse online or download pdf Remanufacturing Instructions for Copier Xerox WorkCentre M118. Xerox WorkCentre M118 14 pages. Drum cartridge remanufacturing
Also for Xerox WorkCentre M118: User Manual (2 pages), Module Manual (2 pages), Quick Installation Card (2 pages), Software Manual (47 pages), Quick Setup Manual (5 pages), Quick Setup Manual (5 pages), Manual (28 pages), Stand Installation Manual (4 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (1 pages), Installation Manual (1 pages), Getting Started Manual (25 pages), Evaluator Manual (12 pages), Service Manual (12 pages)

Print Page
Xerox WorkCentre M118 Remanufacturing Instructions
XEROX WORKCENTRE M118 • 128 DRUM CARTRIDGE REMANUFACTURING INSTRUCTIONS
REMANUFACTURING THE XEROX WORKCENTRE
M118/128 DRUM CARTRIDGE
By the Technical Staff at UniNet

SUPPLIES REQUIRED

1. Xerox WorkCentre M 118/128 developer (used in OPC cartridge)
2. Xerox WorkCentre M 118/128 drum cartridge replacement chip
3. Xerox WorkCentre M 118/128 OPC drum
4. Xerox WorkCentre M 118/128 wiper blade
5. Conductive Grease

TOOLS REQUIRED

1. Phillips head screwdriver
2. Small common screwdriver
3. Vacuum approved for toner
1. Remove the two screws located on the handle side end cap. Remove the end cap.
www.uninetimaging.com
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]