Direct power BH26S3 Safety And Operating Manual - Page 10

Browse online or download pdf Safety And Operating Manual for Rotary Hammer Direct power BH26S3. Direct power BH26S3 17 pages. 5kg sds plus rotary hammer drill

Print Page
Fig 6
Fig 7
Fig 8
Fig 9
See Fig 3. If the SDS tool is not located repeat the
installation operation again.
Dial
selector
6. OPERATING THE ON/OFF SWITCH
Holding the Rotary Hammer with both hands
and press the single speed on/off switch in for
Dial
selector
operation (see Fig 4), release switch to stop.
lock
gearbox.Before operating, select required
mode by aligning symbol on switch with
arrow. And ensure selector is positioned.
It could cause a hazard if the selector
switch is not firmly locked.
Note: Press the dial selector lock before
adjusting the dial selector anytime.

7. HAMMER DRILL FUNCTION

1 Adjust the lever selector to position
"
2 Adjust the dial selector to position
"
3 you are now set up for drilling into masonry.

8. CHISEL FUNCTION

1 Adjust the lever selector to position
"
2 Adjust the dial selector to position
" " to stop rotation of the chuck (see Fig 8)
3 you are now set up for chisel work using
hammer action.
To fit a chisel bit, see FITTING SDS TOOLS OR
CHUCK on page 9. The chisel will be gripped
firmly by its shank.

9. DRILLING FUNCTION

1 Adjust the lever selector to position
" " to stop the hammer action (see Fig 9)
2 Adjust the dial selector to position
"
(see Fig 10)
3 you are now set up for chisel work using
hammer action.
10. USING THE DEPTH GAUGE:
1. Rotate the handle anti-clockwise, insert depth
gauge into the handle (see Fig 11).
2. Adjust the depth gauge to desired depth.
WARNING!If the hammer/drill selector
can not go into position, turn the
" to provide the hammer action (see Fig 5)
" to provide rotation of the chuck (see Fig 6)
" to provide the hammer action (see Fig 7)
" to provide rotation of the chuck