Xerox M123 WorkCentre Reference Manual - Page 14

Browse online or download pdf Reference Manual for Printer Accessories Xerox M123 WorkCentre. Xerox M123 WorkCentre 20 pages. Stand installation guide
Also for Xerox M123 WorkCentre: Installation Manual (2 pages), Evaluator Manual (12 pages), Brochure & Specs (6 pages), Install Manual (2 pages), Network Manual (50 pages), Scan Manual (28 pages), Quick Installation Card (2 pages), Manual (28 pages), Office Finisher Installation Manual (6 pages), Office Finisher Installation Manual (6 pages), Hardware Installation Manual (4 pages), High Capacity Tray Installation Manual (3 pages), High Capacity Tray Installation Manual (3 pages), Hard Drive Kit Installation Manual (2 pages), Inverter Installation Manual (2 pages), Installation Manual (2 pages), Hardware Installation Manual (2 pages), Stand Installation Manual (2 pages), Quick Network Setup Manual (7 pages), Service Manual (22 pages)

Print Page
Xerox M123 WorkCentre Reference Manual
Feature
Simplex
Duplex
Orientation
Force short
edge feeding
Job Mode
Job Type
Page
14
dc05cc0364
Implementation
<ESC>&l int X
@PJL SET DUPLEX =
value1
<ESC>&l int S
@PJL SET DUPLEX =
value1
@PJL SET BINDING =
value2
<ESC>&l int S
@PJL SET ORIENTATION
= value
<ESC>&l int O
@PJL SET
PAPERDIRECTION = value
@PJL JOB MODE = value
@PJL SET HOLD = value
(see Example 3)
@PJL SET HOLD = value
@PJL SET
HOLDKEY="four-digit string"
(see Example 4)
Values
Where int is:
1～999
Where value1 = OFF (simplex)
Where int is one of the following:
0 = simplex
Where value1 = ON (duplex)
Where value2 is one of the following:
LONGEDGE
SHORTEDGE
(Use value2 combined with value1 =
ON)
Where int is one of the following:
1 = Duplex long edge binding
2 = Duplex short edge binding
Where value is one of the following:
PORTRAIT
LANDSCAPE
Where int is one of the following:
0 = Portrait
1 = Landscape
2 = Reverse portrait
3 = Reverse landscape
Where value is one of the following:
SEF = Short Edge Feed
LEF = Long Edge Feed
Where value = PRINTER
Where value = PROOF (proof print)
Where value = STORE (confidential
print)
The
HOLDKEY variable acts as a password
to release a job held by the Store value
The variable value is any four-digit
value from 0000 to 9999. The default
value is "".
WorkCentre M128/M123 Reference Guide
.