Xerox WorkCentre M118 Quick Setup Manual - Page 5

Browse online or download pdf Quick Setup Manual for Software Xerox WorkCentre M118. Xerox WorkCentre M118 5 pages. Drum cartridge remanufacturing
Also for Xerox WorkCentre M118: User Manual (2 pages), Module Manual (2 pages), Quick Installation Card (2 pages), Software Manual (47 pages), Quick Setup Manual (5 pages), Manual (28 pages), Stand Installation Manual (4 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (2 pages), Installation Manual (1 pages), Installation Manual (1 pages), Getting Started Manual (25 pages), Evaluator Manual (12 pages), Service Manual (12 pages), Remanufacturing Instructions (14 pages)

Xerox WorkCentre M118 Quick Setup Manual
Verifying Scan to E-mail Setup
Send a test E-mail to verify the Scan to E-mail setup:
1.
Load a sample document into the document feeder.
2.
On the control panel, press the E-mail button.
3.
Press the Address Book button.
4.
In the menu, highlight the address book entry you created, and then press the Next Address button to
select it.
5.
Press the Enter button.
6.
Press the green Start button to scan the document and send it as an attachment to the selected recipient.
7.
Verify that the recipient received the E-mail with the scanned document as an attachment.

Troubleshooting Scan to E-mail

If the machine reports an SMTP error, use the following table to determine the cause and resolution:
Possible Cause
Incorrect mail server host name
Incorrect "From:" E-mail address
entered
The corporate or ISP mail server
requires authentication
The corporate or ISP mail server
does not allow mail on the
standard port number 25
Resolution
Verify that the correct corporate or ISP mail server name has been entered in
the SMTP Host Name field.
Ensure that DNS information is entered correctly.
Verify that the Administrator E-mail Address is correct. The E-mail address must
match what the corporate or ISP mail server is expecting.
Check with your network administrator or ISP to determine if the mail server
requires authentication. If so, use CentreWare IS to enable "POP before SMTP"
authentication, and then enter the POP User Name and POP Password
information.
Check with your network administrator or ISP to verify that Port 25 is being used for
mail service. If not, obtain the mail service port information, and then use
CentreWare IS to configure it.
Xerox WorkCentre M118i
5
Verifying Scan to E-mail Setup