Xerox Fiery EXP4110 Customer Release Notes - Page 4

Browse online or download pdf Customer Release Notes for Print Server Xerox Fiery EXP4110. Xerox Fiery EXP4110 24 pages. Server & controller solutions printing from mac os
Also for Xerox Fiery EXP4110: Manual For Operators (1 pages), Print Options (24 pages), Printing Manual (24 pages)

Print Page

Xerox Fiery EXP4110 Customer Release Notes

Page 4

Garbled diagnostic message (Brazilian Portuguese)

In the Brazilian Portuguese server, if you right-click FieryBar and choose

Run Diagnostics >Test I/F board, the message that appears is garbled.

Time synchronization

In local Setup, when you specify a time server for synchronizing the date and time for the ﬁrst

time (General Setup > Date/Time), the system time of the Fiery EXP4110 does not

synchronize and the server name does not appear on the Conﬁguration page. Also, the

Windows Time Service does not stop when you clear the Set Time and Date Automatically

option. As a workaround, manually set the time and date, and then select Set Time and Date

Automatically in Setup.

Settings for PostScript and PCL

When you make a setting for the Offset Mode option in PS Setup, the settings might not

change. This happens because the values are determined by the settings indicated in PCL

Setup. Because PCL settings are saved after PS settings in Fiery Setup, PS settings are always

overridden.

Network

Ethernet speed

The Ethernet Speed option in Network Setup on the Fiery EXP4110 Control Panel lists two

choices that are not supported: 10BASE-TX (Full Duplex) and 100BASE-TX (Full Duplex).

It does not list a choice for 1 Gbit per second (1 Gbps). To set the speed to 1 Gbps, use

Conﬁgure.

NDS Setup

To enable PServer Mode and NDS in Network Setup, ﬁrst select the Enable PServer Mode

option, and then wait until the cursor returns to the Idle state before you select the Enable

NDS option.

IPX Frame type

In Conﬁgure > Network Setup, you can select multiple IPX Frame types. However, Network

Setup on the Fiery EXP4110 Control Panel allows you to select only one IPX Frame type.

If you select multiple types through Conﬁgure, only one is shown in the Fiery EXP4110

Control Panel.

Maximum number of users for SMB

The Fiery EXP4110 supports a total of eight simultaneous SMB connections, including the

Direct connection, Print queue, and Hold queue.

Part Number: 45051581