Xerox FreeFlow Release Note - Page 10

Browse online or download pdf Release Note for Print Server Xerox FreeFlow. Xerox FreeFlow 33 pages. For color 560/570 printer
Also for Xerox FreeFlow: Installation Manual (34 pages), Brochure (2 pages), Release Note (23 pages), Install Manual (2 pages), Security Manual (38 pages), Important Installation Information (2 pages), User Manual (50 pages), Manual (18 pages), Quick Connect Manual (2 pages), Carrier Procedures Manual (28 pages)

Print Page

5 New Features of 10.3.3 b 106

Version 10.3.3 build 106 is intended to be a SPAR release for the HFT, and PUN controllers.

The following features were added as part of those SPAR fixes.

Versions of FreeFlow Accxes prior to 11.3 did not apply the Accxes contrast/lightness settings to

PDF or PostScript prints. These settings may now be used to adjust contrast and lightness on

PDF and PostScript prints.

The internal selection of tone curves and halftone screens for PostScript/PDF files has been

improved for certain document types

This allows users to control technical details of how PDF files are printed. All PDF files are

internally converted to PostScript for printing. This new selection (on the Postscript emulations

tab in WebPMT) allows a choice between conversion to PostScript Level 2 or PostScript 3. Prior

versions of Accxes had always converted to PostScript 3. Setting this selection to "2" may allow

certain files to print. However, it may also prevent other PDF files from printing; the default

setting of 3 should always be chosen unless specific PDF printing problems arise.

Support was added for the new releases of the following IOT firmware versions:

721:

6030/6050:

If 880mm paper is loaded and configured on the 6030/6050 it will be recognized by the FreeFlow

Accxes controller. The 880mm media will be displayed and used for printing and copying.

Page 10

01.05.00

4.1.06