ALDER TAPWARE Vito Bertoni QAAD SINK MIXER Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Plumbing Product ALDER TAPWARE Vito Bertoni QAAD SINK MIXER. ALDER TAPWARE Vito Bertoni QAAD SINK MIXER 2 pages.

Print Page
INSTALLATION
This set up will allow:
1. Left hand operation is recommended, however there is a choice of
installation positions to suit your needs – left, right or center.
2. Cold setting when lever is at vertical position when installed.
Your Mixer comes fully assembled.
For installation follow steps below:
1. Flush out all pipe work before installation of the mixer
2. Figure 3 - Screw in M8 fixing stud (4) to underside of body and remove the
locknut (5).
3. Push on base square ring (1)
4. Screw in flexible connectors (6) – blue markings to the cold and red
markings for the hot.
5. Feed flexible connectors through mounting hole in sink/deck/counter
6. From underneath, install / fit horseshoe rubber washer (2), horseshoe
fixing plate (3) and locknut (5)
7. Use a tube spanner to tighten mixer to sink.
8. Connect hot & cold flexible connectors to supply inlets.
NOTE:
Flexible connectors must not be kinked, stretched, twisted or in tension
when fitted.
Flexible connectors must not be installed with a curvature radius of no
less than 6 times the outside diameter.
Ensure hoses are not exposed to abrasive or corrosive agents or a naked
flame.
Hoses must be inspected regularly for signs of corrosion to the stainless
braid and replaced immediately if sighted.
FREECALL: 1800 800 919
For all servicing needs, please contact CUSTOMER SERVICE on:
PHONE: 08 6217 0600
www.aldertapware.com.au
FAX: 08 6217 0699
www.vitobertoni.com.au
FIG 1
FIG 2
FIG 3
V02 160520