Alderlea T5 Installation & Operation Manual - Page 15

Browse online or download pdf Installation & Operation Manual for Stove Alderlea T5. Alderlea T5 20 pages.

Print Page

020512-20 ALT5

Disposal of Ashes

Ashes should be placed in a metal container with a tight fi tting lid. The closed container of

ashes should be placed outside on a non-combustible fl oor or on the ground, well away

from all combustible materials, pending fi nal disposal. If the ashes are disposed of by burial

in soil or otherwise locally dispersed, they should be retained in a closed container until all

cinders have thoroughly cooled. Other waste should not be placed in this container.

Chimney connector pipe should be disconnected from stove to clean and inspect.

Only if this is not possible should you remove baffle assembly.

DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.

Remove retaining pin located at the rear top of the fi rebox, just below the

baffle. Lift baffle up and pull forward to disconnect from the supply tube. Tilt baffle

sideways to drop down and remove from fi rebox. Inspect gasket between baffle

and supply tube. If necessary, replace with gasket #SSER.1395 available from

your Pacifi c Energy dealer. Re-install baffle assembly in reverse order. The two

side pieces of insulation must be tight against the siderails.

The optional blower kit (kit #WODC.BLOW) is equipped with a three prong power

cord and may be installed at any time. Follow installation instructions supplied with

the kit. Route power supply cord away from heater.

Electrical rating: 115 volts A.C.- 0.84 amps.

Fan output rating: 125 CFM

Proper blower speed matched with air control setting will ensure peak performance

from your stove. Operate as follows:

• Air control set to low (right position), operate blower speed control on "Low".

• Air control set between low and high (middle position), operate blower

speed control at desired setting.

Automatic: To operate the blower automatically, set the rocker switch on the

side of the fan housing to "Auto" and set the speed control to desired setting. This

will allow the fan to turn on as the stove heats up to operating temperature. It will

also shut the blower off after the fi re has gone out and the unit cooled to below a

useful heat output range.

Manual: To manually operate the blower, set the rocker switch to "Man" and set

the speed control to desired setting. This will bypass the sensing device and allow

full control of the blower.

Switching from "Auto" to "Man" or selecting speed may be done anytime.