Alderon Industries 7039 User Manual - Page 3

Browse online or download pdf User Manual for Measuring Instruments Alderon Industries 7039. Alderon Industries 7039 16 pages. Cast iron cable weight control and pump switches

Print Page
Alderon Industries 7039 User Manual

Introduction

The cast iron cable weight is used as a pivot point for the activation of a control or pump float switch. Typically used in a tank where
the float switch cable is suspended from a mounted float bracket or per local codes. This product can be used with different types
of float switches for a variety of applications, including but not limited to: lift stations, septic tanks, holding tanks, pump chambers,
and water tanks for liquids up to 200° F. Made with zinc plated cast iron.

Safety Guidelines

Before proceeding with the installation or operation of this product, read all instructions thoroughly, as well as complying with
all federal, state and local codes, regulations, and practices. This product must be installed by qualified personnel familiar with
all applicable local electrical and mechanical codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install
and test this product can result in personal injury or equipment malfunction.
1. DISCONNECT POWER when installing or servicing the product. Failure to disconnect all power sources could result in
serious injury or death.
2. NEVER enter a flooded space without proper Personal Protective Equipment (PPE). Always wear dielectric rubber boots
and other applicable protective equipment when water is on the floor and you must service an energized pump, alarm
system, or product.
3. DO NOT enter the water if the water level is higher than that of the protection your PPE offers or if your PPE is not
watertight.
4. DO NOT use this product with or near flammable liquids.
5. DO NOT install this product in locations classified as hazardous or in explosive atmospheres as defined by any applicable
electrical safety code.
Cast Iron Cable Weight - USER GUIDE
WARNING
Alderon Industries™ - Leading Edge Control Products | 3