Yamaha disklavier Mark IV Series User Manual - Page 43
Browse online or download pdf User Manual for Musical Instrument Yamaha disklavier Mark IV Series. Yamaha disklavier Mark IV Series 45 pages. Yamaha digital piano quick guide
Also for Yamaha disklavier Mark IV Series: Quick Manual (22 pages), Quick Manual (22 pages)
Print Page
Speakers
Symptom
The audio from the speakers is
not in sync with the video (audio is
delayed).
The audio from the speakers is
not in sync with the piano
playback (audio is delayed).
No sound is heard from the
speakers.
The speaker volume is too low.
No video sound is heard from the
speakers connected to the
OUTPUT jacks.
The left channel sound is heard
more than once or seems to have
an echo.
No sound is heard from the
speakers.
The speaker volume is too low.
Hissing sound is coming from the
speakers.
Speaker output is unstable.
Audio input through the USB audio
input jack is being mixed into the
speaker sound (in case you are
using the USB audio interface).
No sound is output from the USB
audio interface.
Remedy
See page 34 to adjust the delay.
Check the audio delay specifications of the speakers.
See page 34 to adjust the delay.
Check the audio delay specifications of the speakers.
Make sure that the speakers are turned on.
Make sure that the audio cable is firmly connected to the speaker.
Make sure that the audio cable is not disconnected.
Make sure that the speaker volume is adequately turned up.
Make sure that the volume of the desired input is turned up.
Make sure that you are using the audio cable without impedance
changer.
See page 28 to adjust audio balance.
See page 28 to adjust main volume.
It is possible that you have the DisklavierTV website opened more than
once. Make sure that ONLY the DisklavierTV website is opened.
Reboot your computer.
Make sure that the audio volume of computer is adequately turned up.
Make sure that the audio cable is correctly connected to the audio input
jack.
Make sure that the USB audio driver is correctly installed on your
computer.
Make sure that USB audio is selected in the audio device setting on
your computer.
Make sure that the USB audio output volume is adequately turned up.
Make sure that the audio volume of computer is adequately turned up.
Make sure that you are using the audio cable without impedance
changer.
Replace the audio cable.
In case you are using the USB audio interface, make sure that the USB
audio output volume is adequately turned up.
Make sure that the surround system on your computer is TURNED OFF.
Audio enhancements prevent DisklavierTV from working properly.
Reverse the left and right connection, and then check the sound is
appropriately output from the speakers.
Replace the audio cable.
Make sure that you are using the stereo audio cable.
Make sure that the audio cable is firmly connected to the audio input jack
on your computer. If symptom persists, connect the headphones to the
jack and try listening to audio playback to confirm whether the jack is
defective or not.
Replace the audio cable.
Make sure that only the input from your computer is connected to the
USB audio interface. If the input from any other device is connected,
disconnect it or set its volume to 0.
Make sure that the output on the USB audio interface are correctly
connected to your Disklavier.
Troubleshooting
DisklavierTV User's Guide (For Disklavier Mark IV Users)
43