Yamaha YCHS7018 Owner's Manual - Page 7
Browse online or download pdf Owner's Manual for Musical Instrument Yamaha YCHS7018. Yamaha YCHS7018 10 pages. Chimes & chime stand
Print Page
Attaching the Sound Tubes
Install the sound tubes with the damper released.
1.
Put the sound tubes on a stable, flat, level
surface.
To prevent damage to the tubes, place a soft cloth on
the floor where the tubes will be placed.
2.
Remove the protective film that was applied
to the sound tube surface.
3.
Hook both end balls of the wire in the
grooves of the hanger.
At this time, turn the note name toward the player.
Note name
End ball
Hanger
YCH7018, YCH6018, YCHS7018
Generally, arrange the sound tubes as shown
below. The places filled with gray are not used.
Accidental tone side
Long tube
Natural
tone side
Replacing the Wire
1.
Hold the sound tube while being careful not
to contact other sound tubes and stand,
detach the end balls from the grooves of the
hanger, and then remove the sound tube.
End ball
End ball
Hanger
Short tube
End ball
2.
Put the sound tubes on a stable, flat, level
surface.
To prevent damage to the tubes, place a soft cloth on
the floor where the tubes will be placed.
3.
Remove the wire caps.
When removing the wire cap, pass the wire through
the slit of the wire cap.
Wire
4.
Replace the wire.
5.
Attach the wire caps to the sound tube.
Wire
The wire is structured by multiple strands of thin
metal wires. When a thin metal wire is cut, replace
the wire with a wire which is not damaged. If the
CAUTION
wire is broken, the sound tube might fall, and possi-
bly causing injury.
NOTE
• Replace the wire cap if it is damaged. If you keep using the
damaged wire cap, the wire will be easily damaged. Please
contact qualified Yamaha service personnel about the wire cap
(sold separately) for replacement.
• Since the wire caps are very small and can be easily lost, be
careful when handling them.
YCH7018 YCH6018 YCHS7018 YCHS7006 Owner's Manual•7
Assembly Procedure
Wire cap
Slit
Wire cap
Slit