Yamaha DG-Stomp Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Amplifier Yamaha DG-Stomp. Yamaha DG-Stomp 32 pages. Guitar pre-amplifier with effects
Also for Yamaha DG-Stomp: Supplementary Manual (1 pages), Service Manual (43 pages)

Print Page

Rear Panel

@6 Power Switch (STAND-BY ON/OFF)

Power switch for the main unit.

* To protect the speakers, set the OUTPUT knob

before switching the power ON/OFF.

@7 Power Adaptor Jack (AC IN 12V 700mA)

Connect the supplied power adaptor to this jack.

* Never use a power adaptor other than the supplied adaptor.

Use of any other power adaptor may cause damage, over-

heating, fire, etc.

@8 MIDI OUT Jack

Jack used for transmitting MIDI data from the DG-

Stomp such as control changes, program changes,

data in the DG-Stomp's memory, etc. (

@9 MIDI IN Jack

Jack used for receiving MIDI data from a MIDI de-

vice, such as a MIDI foot controller, that can be used

to control the volume, or each of the effects and

select patches in the DG-Stomp. (

Also, DG-Stomp memory data saved to an external

MIDI device can be returned to the DG-Stomp via

this jack. (

page 25)

#0 Digital Out Jack (DIGITAL OUT)

Jack used for sending the output of the DG-Stomp

as digital data.

Connect to a device equipped with a digital input

jack (COAXIAL) such as a digital mixer, etc. (

11).

to "0"

page 24).

page 16).

page

#1 EXP Pedal Jack (EXP. PEDAL)

Connect a foot controller (expression pedal) (op-

tional) such as the YAMAHA FC-7, etc. to this jack,

and control DG-Stomp parameters or use the de-

vice as a wah pedal. (

#2 Headphones Jack (PHONES)

Connect a pair of headphones (optional) to this jack

for private practice or practicing at night when you

don't want to disturb others. (

* Even when headphones are used, the audio signal is

delivered from the OUTPUT jack

# 0

OUT jack

#3 Output Jacks (OUTPUT R, L/MONO)

The analog output jacks for the DG-Stomp. Con-

nect these jacks to the input jack on a power ampli-

fier + speaker set or guitar amp, mixer, etc. (

10)

* Use the L/MONO jack when connecting to a monaural de-

vice.

#4 Input Jack (INPUT)

#5 Input Level Switch (LOW/HIGH)

The DG-Stomp's input jack. Connect a guitar here.

Select either LOW/HIGH to match the output level

of the guitar you are using. Use the LOW setting for

high output guitars and the HIGH setting for low

output guitars.

* Make sure the power is switched OFF before connecting a

guitar.

Nomenclature

pages 21, 25)

page 11).

and the DIGITAL

page