Yamaha ATS-1010BL Owner's Manual - Page 17

Browse online or download pdf Owner's Manual for Speaker System Yamaha ATS-1010BL. Yamaha ATS-1010BL 20 pages. Front surround system

Print Page

Problem

The volume, subwoofer and

audio delay time is not

adjustable.

The unit does not learn the

operation of TV remote

control.

The power state of the unit

and of your TV is opposite.

(For example, though your

TV is on, the unit is in

standby mode.)

The TV remote control is out

of work even if you use TV

remote control relay

function.

You cannot use 3D glasses. The unit obstructs the 3D glasses transmitter of

The picture on your TV

screen becomes blurred or

distorted.

Contact your nearest authorized Yamaha dealer or service center if the following problem occurs.

Problem

The power of the unit

immediately shuts off, and

the INPUT indicator flashes.

Cause

The adjustment has reached the maximum or

minimum.

The remote control sensor of the unit may be

exposed to direct sunlight or lighting.

The screen glare of TV disturbs the remote

control signal.

The batteries of TV remote control may be worn

out.

The button of the unit was not pressed long

enough for the remote control learning

operation.

The TV remote control is not available for

remote control learning.

The TV remote control is outside of the

operation range.

The unit does not enter the remote control

learning mode.

The power state of the unit and of your TV is

opposite from the beginning.

The unit and TV are too close/far from one

another.

Something is between the unit and your TV.

The TV remote control relay function is not

activated.

The TV remote control is not compatible with

the TV remote control relay function.

your TV.

The unit is too close to your CRT TV.

Cause

The protection circuit is activated.

Solution

Reposition the unit.

Disconnect the power cable and perform the

remote control learning operation again.

Replace the batteries.

Press the button of TV remote control in the

order "press 1 second" → "release 1 second" →

"press 1 second"

Use the remote control of the unit.

Point your TV remote control towards the

remote control sensor of the unit keeping a

distance of 30 cm (1 ft) between them.

Operate after checking that the INPUT

indicator is flashing in red.

Press the power button of TV remote control to

set your TV and the unit to standby mode after

pressing the power button of your TV itself and

of the unit to set both your TV and the unit to on.

Try to use the TV remote control relay function

again after repositioning the TV remote control

signal transmitter of the unit and the remote

control sensor of your TV.

Try to use the TV remote control relay function

again after adjusting the height of the unit by

removing or attaching its stands.

Remove the obstruction.

Restart the unit and check the indicator status.

Place the unit (without the stands, for example)

so as not to hide the remote control sensor of

your TV.

Check the position of 3D glasses transmitter of

your TV by referring to the manual of your TV,

and move the unit to the position where there is

no obstruction.

Move the unit away from your TV.

Solution

Troubleshooting

See

page

—

See

page

—