Yamaha DSP-E200 Owner's Manual - Page 18

Browse online or download pdf Owner's Manual for Speaker System Yamaha DSP-E200. Yamaha DSP-E200 19 pages. Natural sound digital sound field processor

Print Page

TROUBLESHOOTING

If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple

measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and

contact your authorized YAMAHA dealer or service center for help.

SYMPTOM

The unit fails to turn on when the POWER

switch is pressed.

No sound.

The sound suddenly goes off.

Only one side speaker outputs the sound.

Sound "hums".

No sound from the rear speakers.

No sound from the center speaker.

The remote control transmitter does not

work.

The distance or range within which the

remote control transmitter can be used

decreases.

The sound is degraded when monitoring

is performed by using the headphones

connected to the compact disc player or

cassette deck which are connected with

this unit.

CAUSE

Power cord is not plugged in or is not

completely inserted.

Incorrect output cord connections.

The MUTING switch is ON.

The protection circuit has activated because

of short circuit etc.

Incorrect cord connections.

The rear effect sound output level is set to 0.

The monaural sound source is played in the

DOLBY PRO LOGIC or ENHANCED.

The center sound output level is set to 0.

The center mode is in the PHANTOM.

Incorrect sound field program selection.

No sound field program is selected.

Direct sunlight or lighting (of an inverter type

of flourescent lamp etc.) is striking the

remote control sensor of the main unit.

The batteries of this remote control

transmitter are too weak.

Power cord of this unit is not plugged.

REMEDY

Firmly plug in the power cord.

Connect the cords properly. If the problem

persists, the cords may be defective.

First, turn the volume control to the full left.

Then, turn the MUTING switch off with the

remote control transmitter and adjust the

volume.

Turning the unit off and then on will reset the

protection circuit.

Connect the cords properly. If the problem

persists, the cords may be defective.

Firmly connect the audio plugs. If the

problem persists, the cords may be

defective.

Turn up the sound output level with the

REAR LEVEL keys.

Select another program suitable for the

monaural sound source.

Turn up the sound output level with the

CENTER LEVEL keys.

Select the NORMAL or WIDE.

Select an appropriate program.

Change position of the main unit.

Replace the batteries with new ones.

Plug in the power cord.