Ecoplus 727186 Instruction For Installation And Maintenance - Page 6

Browse online or download pdf Instruction For Installation And Maintenance for Water Pump Ecoplus 727186. Ecoplus 727186 12 pages. Commercial grade, automatic submersible pump

Print Page

THE PUMP MUST BE SUPPORTED BY A BASE. NEVER SUSPEND THE PUMP FROM PIPES.

3. MANAGEMENT

3.1 Storage:

vibrations. Keep the pump in its original packaging until time of installation.

3.2 Transport:

4. WARNINGS

Do not carry pump by the power cable. Always carry pump using the handle.

• Never allow the pump to run dry.

• The sealing device contains a non-toxic lubricant which may alter the characteristics of pure

water in the unlikely event of leaks.

5. INSTALLATION

The electrical system must be compliant with local codes.

Screw on the elbow with hose-tail fitting provided. Use a

pipe tightening clamp to secure the pipe to the fitting.

• If the bottom of the trap where the pump is to be placed

is particularly dirty, a raised support should be provided

so as to avoid blocking of the suction grid (Fig.1)

• Totally immerse the pump in the water.

• Ensure that the minimum dimensions of the trap in

which it is housed are as follows:

Min. base dimensions 7.87"x7.87" (200x200 mm)

Min. height 15.75" (400 mm)

• The dimensions of the trap must always be in relation

to the quantity of water arriving and to the flow of the

pump, so as not to subject the motor to excessive

starts/hour. It is strongly recommended not to

exceed 20 starts/hour.

ALWAYS INSTALL THE PUMP IN VERTICAL POSITION.

6. ELECTRICAL CONNECTION

The length of the power cable limits the maximum depth of pump immersion.

Follow the indications on the technical data plate and technical specifications on page 3.

Pump must be stored in a dry, dust free covered area that is free from

Avoid subjecting the pump to needless impacts and collisions.

(Fig.1)