Clark GPX17E Service Manual - Page 4

Browse online or download pdf Service Manual for Compact Loader Clark GPX17E. Clark GPX17E 13 pages.

Print Page

Group 00, Engine

5. Remove the muffler and tailpipe as an assembly.

First loosen the clamps on each end of the muffler. This

will free the muffler and tail pipe.

6. Remove the exhaust pipe. Disconnect the exhaust

pipe from the engine exhaust manifold by removing

three fasteners at the flange joint and removing the

exhaust pipe together with the ring and the gasket.

7. Remove the radiator.

First, drain thecooling systemof fluid. Next, remove the

four capscrews which fasten the radiator cover to the

frame and remove the cover.

This will expose the

radiator top mounting brackets. Then, remove the two

bolts fastening each bracket and remove the brackets

and the pads under each bracket.

Unfasten the hose clamps from the inlet and outlet

water hoses at the radiator and pull the hoses off the

radiator.

Remove the transmission cooling lines from the radia-

tor by unfastening the fittings. Note or mark which is

theshortest line and where it fastens to the radiator.

Lift the radiator out of truck and store in a safe location.

8. Remove the radiator shroud.

9. Disconnect the fuel line from the fuel pump.

10. Remove the four screws from the dash panel which

will let the wiring and instruments remain with the

engine. Use wire ortape to hold the panel to the engine

to prevent damage to it when the engine is removed.

11. Connect a short section of lift chain of correct

capacity to the engine lifting eyes, using bolts to fasten

the chain to the eyes. One eye is bolted to the engine

block LH side at the rear; the other is bolted to the RH

side near the front. Connect a chain hoist to this lift

chain and raise slightly to remove all slack.

00-l-12

Engine

SM 619, Jan '98