Clark Synthesis Prosound429 Installation Manual - Page 2

Browse online or download pdf Installation Manual for Transducer Clark Synthesis Prosound429. Clark Synthesis Prosound429 9 pages.

Print Page

IMPORTANT PRODUCT INFORMATION

1. DO NOT DROP THE PROSOUND429- The Prosound429 can be damaged both internally and externally if

dropped. Damage caused by dropping the Prosound429 is not covered under the warranty.

2. DO NOT EXPOSE THE PROSOUND429 TO HIGH DISTORTION LEVELS- Exposing the Prosound429 to high

levels of distortion may damage the unit. This type of damage is not covered under the warranty. If the

Prosound429 stops playing, it is likely that the built-in protection circuit has activated. In the event this

happens, turn the amplifier off for approximately 60 seconds to allow the circuit to reset. Turn down the

volume on the input signal and amplifier. Operate the system at lower volume levels to avoid overloading

the Prosound429.

3. USE CAUTION WHEN MOVING OR TURNING DRUM THRONES- If using this Prosound429 on a drum

throne, insure the Prosound429 is protected from hitting the stand or other components. When sitting

down on, or standing up from, the drum throne, insure the throne does not tip over. If the throne falls

over, the Prosound429 may be damaged. Do not spin the throne with the Prosound429(s) attached. Severe

damage may occur. These types of damage are not covered under the warranty.

4. INSTALL AND USE TC-101 AMPLIFIER INTERFACE- Install the TC-101 Amplifier Interface in-line between

the amplifier and the Prosound429. This device is intended to dampen peak signals that may damage the

Prosound429. Damage caused to the Prosound429 by failing to use the Amplifier Interface will not be

covered under warranty.

5. CABLE PLACEMENT- Use caution when running the cable from the amplifier to the Prosound429. Do not

lay the cable in high-traffic areas where tripping or entanglement may occur.

6. DO NOT CARRY PROSOUND429 BY ITS CABLE- Never carry the Prosound429 by its cable. This can

damage the strain relief and internal wiring of the Prosound429. Damage of this type will not be covered

under the warranty.

7. DO NOT REMOVE THE STRAIN RELIEF- Removing or altering the strain relief fitting connecting the wire

to the Prosound429 may permanently damage the Prosound429. This fitting is carefully installed at the

factory. Any alteration or adjustment of this fitting will void the warranty.

8. AVOID EXCESSIVE HEAT- Exposure to excessive heat will result in internal temperatures that can cause

damage to the components. Damage caused by neglect will not be covered under warranty.

9. STORAGE- Insure the components are adequately protected when storing or transporting.

10. USE PROPER AMPLIFICATION- Insure the Prosound429 is being powered by an amplifier that is stable at 4

ohms and delivers at least 125 to 150 watts into 4 ohms into each Prosound429. If the lights inside the TC-

101 Amplifier Interface are flashing brightly, turn down the gain on the amplifier and volume of the input

signal going to the Prosound429.

11. VOLUME CONTROLS- Do not use with external volume controls rated at less than 150 watts.

Prosound429