Installation: Traditional Floors & Platforms
TRADITIONAL FLOORS
Transducers may be mounted under a floor by attaching a
hardwood bridge between adjacent floor joists, or by installing
a 2" x 6" bridge with a curved niche. When installing under a
floor, access may be from the basement or the ceiling below the
floor. The TST will be mounted to a bridge connected between
adjacent floor joists.
If your goal is to excite the area of the floor directly beneath a
chair, then attach the Transducer to the closest joist underneath
the chair.
Note: Carpeting and padding may reduce the tactile effect.
PLATFORMS
Recommendation: Clark Synthesis recommends using only
TST429 Platinum Transducers for platforms. Use of (1) TST429
Platinum Transducer for every 4 ft. by 8 ft. area of the platform is
suggested.
Platforms are a great alternative to mounting a
Transducer directly to a chair. This method is especially practical
in home theaters with multiple rows of seating placed on
platforms. An activated platform will deliver tactile sensations to
your feet as well as the rest of your body via the chair.
Whether constructing a new platform or fitting Transducers onto
an existing one, it is best to space the Transducers an equal
distance from each other and the edges of the platform. If using
only one Transducer, locate the Transducer in the center of
the platform. Be sure to leave a way to access the Transducer
should service be required.
To minimize energy loss into the floor, use Isolation Feet
between the platform and the floor. Do not glue a platform to a
concrete floor.
Clark Synthesis recommends using plywood or hardwood for the
platform's top surface. DO NOT USE MDF (medium-density
fiberboard). We highly recommend using adhesive and
screws instead of nails. Loose fitting joints can cause unwanted
vibrations and buzzing noises.
www.clarksynthesis.com
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Mounting Detail
2" x 6" Bridge with Curved Niche
3"
Jam Nut
Glue and screw all joints
Glue and screw
plywood floor surface
to all frame members
including the bridge
Tactile Sound Transducers
6"
9
Print Page