Clark Synthesis TST209 Installation Manual - Page 10
Browse online or download pdf Installation Manual for Transducer Clark Synthesis TST209. Clark Synthesis TST209 16 pages.
Print Page
WIRING & CONNECTIONS
HOME THEATER
There are several different ways to hook up your system in terms of which source material
(signal) is delivered to the amplifier(s) and Transducer(s). Since our inception, we have
discovered that approximately half of our customers prefer using the LFE/SUB signal with
their Transducers. The other half prefer using the Right Front (RF) and Left Front (LF) signals.
Additionally, there are a few people who like to use multiple signals concurrently. In the
following instructions, we provide you with general diagrams for each of these hookup
methods.
LFE/SUB Hookup
The LFE, SUB, or Subwoofer output is the signal that you send to the subwoofer.
If your receiver has only one LFE/SUB/Subwoofer output port, connect a "Y" adapter to that
output. This will allow you to split the signal between the Transducer and the subwoofer. To
do this properly, connect your subwoofer to one side of the "Y" adapter. Connect the amplifier
to the other side of the "Y" adapter. To reduce the amount of noise produced when using this
signal, use another "Y" adapter cable when connecting to the amplifier. This will allow you to
connect the signal into both the Left and Right input connectors on the amplifier.
Amplifier
(100 - 150
Watts into
4 ohms)
Output
Transducer
10
TST209 Transducer
Surround-Sound Receiver
L
R
OUT
IN
–
+
Y Adapter
LFE/SUB
Y Adapter
To Input of
Powered
Subwoofer
www.clarksynthesis.com
Subwoofer