Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installation Manual - Page 8

Browse online or download pdf Installation Manual for Amplifier Clark Synthesis TACTILE SOUND AQ339 Aquasonic. Clark Synthesis TACTILE SOUND AQ339 Aquasonic 12 pages. Underwater speaker
Also for Clark Synthesis TACTILE SOUND AQ339 Aquasonic: Supplementary Manual (4 pages), Specifications (1 pages), Parts List (1 pages), User Manual (1 pages), Reference Sheet (1 pages), Installation Manual (3 pages), Specification (1 pages), Installation Manual (20 pages)

Print Page
Clark Synthesis TACTILE SOUND AQ339 Aquasonic Installation Manual
IN-WALL INSTALLATION
Carefully remove the speaker from its box. Install the mounting gasket around the rubber ring of
1
the sound lens (as shown below). Insure the mounting gasket is installed evenly and is firmly seated
against the entire circumference of the sound lens.
Place the speaker on a non-abrasive surface with the sound lens facing up. Hold the face ring above the
2
sound lens, allowing the clamp tabs to fall open. Set the face ring against the mounting gasket, insuring
each clamp tab is on the outside of the mounting gasket. Hold the entire assembly together and place
it on the non-abrasive surface as shown in the third picture below. Carefully position the sound lens so
it is centered over the face ring.
Pull the bundled speaker wire through the wire clamp. Place the wire clamp under each clamp tab,
3
verifying the nut and bolt adjuster is accessible when the clamp is placed under the tabs. Insure the
mounting gasket and face ring are still evenly centered.
8
www.clarksynthesis.com
Underwater Speaker